Abstract
Sensors created from optical fibers are often used to measure strain due to their high accuracy. However, they are not used as often for higher frequency applications as a result of low sampling rates in their data acquisition systems. Recently, acquisition systems have been developed that satisfy the required specifications for use in acoustic emission (AE), but these types of sensors are not used due to their low signal-to-noise (S/N) ratios. However, there are many studies on the sensitivity enhancement conferred by the fiber Bragg grating sensor (FBG sensor). This sensor is easy to use and does not require specific reference fibers when sensing. In this study, acoustic waveguides, which are usually used in ultrasonic microscopes, were fabricated and used in FBG AE sensors to enhance the S/N ratio. Two types of waveguides were designed; the refraction type and the reflection type. FBG fibers were attached to the waveguides, which were then secured using adhesive to a thin aluminum plate. Impulses were inputted into the sensor by breaking pencil lead on the plate. The results showed that the amplitude of the first wave was increased using these waveguides. Using finite-element method (FEM) analysis, the enhancement of the wave amplitude was also evaluated such that the acoustic waveguide could be used for enhancement of the S/N ratio of FBG sensors.
Similar content being viewed by others
References
Harris DO, Dunegan HL (1974) Acoustic emission – 5: applications of acoustic emission to industrial problems. Nondestruct Test 7(3):137–144
Pacheco-Salazar OF, Wakayama S, Sakai T, Cauich-Rodriguez JV, Rios-Soberanis CR, Cervantes-Uc JM (2015) Evaluation of damage progression and mechanical behavior under compression of bone cements containing core-shell nanoparticles by using acoustic emission technique. J Mech Behav Biomed Mater 46:137–1475
Sakai T, Gushiken T, Rios-Soberanis CR, Masuko T, Matsushima S, Kobayashi S, Yoneyama S, Wakayama S (2015) Fracture behavior of wasted activated carbon powder composites. Adv Compos Mater. doi:10.1080/09243046.2015.1011049
Sakai T, Wakayama S, Perez-Pacheco E, Rodriguez-Laviada J, Rios-Soberanis CR (2013) Damage accumulation behavior of Non-crimp fabric in tension mode (static and cyclic). Adv Compos Mater 70:231–236
Sakai T, Suzuki S, Wakayama S, Yoneyama S, Yamamoto E (2013) Characterization of damage process of rabbit tendon by acoustic emission technique in vitro, 2013 special issue. J Jpn Soc Exp Mech 13:s213–s216.3
Rios-Soberanis C-R, Wakayama S, Sakai T, Cervantes-Uc JM, May-Pat A (2014) Evaluation of mechanical behaviour of bone cements by using acoustic emission technique. Adv Mater Res 856:246–250
Sakai T, Wakayama S, Kametani G, Yoshida K, Akatsu T (2014) Characterization of crack growth resistance under thermal shock on silicon nitride with various microstructure. Bull JSME Mech Eng J 1(1):1–10
Giallorenzi TG, Bucaro JA, Dandridege A, Sigel GH Jr, Cole JH, Rashleigh SC, Priest RG (1982) Optical fiber sensor technology. IEEE J Quantum Electron 18(4):626–665
Pierce SG, Philp WR, Gachagan A, Mcnab A, Hayward G, Culshaw B (1996) Surface-bonded and embedded optical fibers as ultrasonic sensors. Appl Opt 35(25):5191–5197
Tsuda H, Lee JR, Guan Y, Takatsubo J (2007) Investigation of fatigue crack in stainless steel using a mobile fiber bragg grating ultrasonic sensor. Opt Fiber Technol 13:209–214
Tsuda H (2006) Ultrasound and damage detection in CFRP using fiber bragg grating sensors. Compos Sci Technol 66:676–683
Satori K, Fukuchi K, Kurosawa Y, Hongo A and Takeda N (2001) Polyimide-coated small-diameter optical fiber sensors for embed- ding in composite laminate structures. Proc. SPIE, vol. 4328. Newport Beach, CA, USA: SPIE p 285-294
Jiang M (2001) Edmund Gerhard. A simple strain sensor using a thin film as a low-finesse fiber-optic fabry-perot interferometer. Sensors Actuators A Phys 88:41–46
Kageyama K, Ohasawa I, Kanai M, Tanma Y, Nakatani T, Shinomura M, Nagata K and Matsumura F (2003) Application of new optical fiber sensors to reinforced concrete structure for AE detection/monitoring, structural health monitoring and intelligent infrastructure, p 285-290
Graff KF (1991) Wave motion elastic solids. Dover Books on Physics
Qiu C, Zhang X, Liu Z (2015) Far-field imaging of acoustic waves by a two-dimensional sonic crystal. Phys Rev B 71:054302
Knopoef L (1958) Surface motions of a thick plate. J Appl Phys 29(4):661–670
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sakai, T., Suzuki, S. & Wakayama, S. Sensitivity Enhancement of FBG Sensors for Acoustic Emission Using Waveguides. Exp Mech 56, 1439–1447 (2016). https://doi.org/10.1007/s11340-016-0178-6
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11340-016-0178-6