Skip to main content
SpringerLink
Log in

Particle Deposition and Decay in a Chamber and the Implications to Exposure Assessment

  • Published:
Water, Air, and Soil Pollution Aims and scope Submit manuscript

Abstract

Accurate modeling indoor aerosol deposition and decay is an important step for exposure assessment. High deposition rate reduces indoor pollutant concentration and results in lower inhalation exposure. Many of indoor surfaces have random roughness protrusion scales up to several millimeters which it may significantly affect the deposition loss rate. Aerosols deposition onto most indoor surfaces can be considered as “rough’ surface deposition. However, particle deposition from anleaflong indoor environment is frequently modeled by assuming that surfaces are smooth. In this work, experimental results for deposition velocity onto drywall surfaces for supermicron particles from 1 to 7 μm are presented. Deposition velocity is significantly higher than that predicted by a previous published model. To illustrative the influence of particle deposition on exposure, two hypothetical room sizes and two air exchange rates were considered. Inhalation transfer factor was adopted as a risk exposure index. Taking into account of high deposition velocity onto drywall surfaces, inhalation transfer factors are 8 to 35% lower than that predicted by the model and this significant difference is important to the exposure assessment.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  • Abadie, M., Limam, K., & Allard, F. (2001). Indoor particle pollution: Effect of wall textures on particle deposition. Building and Environment, 36, 821–827.

    Article  Google Scholar 

  • Bennett, D.H., McKone, T.E., Evans, J.S., Nazaroff, W.W., Margni, M.D., Jolliet, O., & Smith, K.R. (2002). Defining intake fraction . Environmental Science and Technology, 36, 206A–211A.

    Article  Google Scholar 

  • Chen, F.Z., Yu, S.C.M., & Lai, A.C.K. (2006). Modeling particle distribution and deposition in indoor environments with a new drift-flux model. Atmospheric Environment, 40, 357–367.

    Article  CAS  Google Scholar 

  • Fogh, C.L., Byrne, M.A., Roed, J., & Goddard, A.J.H. (1997). Size specific indoor aerosol deposition measurements and derived I/O concentrations ratios. Atmospheric Environment, 31, 2193–2203.

    Article  CAS  Google Scholar 

  • Furtaw, E.J., Pandian, M.D., Nelson, D.R., & Behar J.V. (1996). Modeling indoor air concentrations near emission sources in imperfectly mixed rooms. Journal of the Air & Waste Management Association, 46, 861–868.

    CAS  Google Scholar 

  • Gadgil, A.J, Lobscheid, C., Abadie, M.O., & Finlayson, E.U. (2003). Indoor pollutant mixing time in an isothermal closed room: an investigation using CFD. Atmospheric Environment, 37, 5577–5586.

    Article  CAS  Google Scholar 

  • Hinds, W.C. (1998). Aerosol Technology: Properties, Behavior, and Measurement of Airborne Particles. 2nd edition. Wiley-Interscience, New York, USA.

  • Hussein, T., Hameri, K., Heikkinen, M.S.A., & Kulmala, M. (2005). Indoor and outdoor particle size characterization at a family house in Espoo-Finland. Atmospheric Environment, 39, 3697–3709.

    Article  CAS  Google Scholar 

  • Lai, A.C.K. (2002). Particle deposition indoors: A review. Indoor Air, 12, 211–214.

    Article  CAS  Google Scholar 

  • Lai, A.C.K. (2005). Modeling of indoor coarse particle deposition onto smooth and rough surfaces. Atmospheric Environment, 39, 3823–3830.

    Article  CAS  Google Scholar 

  • Lai, A.C.K., & Nazaroff, W.W. (2000) Modeling indoor particle deposition from turbulent flow onto smooth surfaces. Journal of Aerosol Science, 31, 463–476.

    Google Scholar 

  • Lai, A.C.K., & Nazaroff, W.W. (2005). Supermicron particle deposition from turbulent flow onto vertical surfaces with varying roughness. Atmospheric Environment, 39, 4893–4900.

    Article  CAS  Google Scholar 

  • Lai, A.C.K., Thatcher, T.L., & Nazaroff, W.W. (2000). Inhalation transfer factors for air pollution health risk assessment. Journal of the Air & Waste Management Association, 50, 688–1699.

    Google Scholar 

  • Long, C.M., Suh, H.H., Catalano, P.J., & Koutrakis, P. (2001). Using time- and size-resolved particulate data to quantify indoor penetration and deposition behavior. Environmental Science and Technology, 35, 2089–2099.

    Article  CAS  Google Scholar 

  • Nazaroff, W.W. (2004). Indoor particle dynamics. Indoor air, 14, 175–183.

    Article  Google Scholar 

  • özkaynak, H., Xue, J., Spengler, J., Wallace, L., Pellizzari, E., & Jenkins, P. (1996). Personal exposure to airborne particles and metals: Results from the Particle TEAM study in Riverside, California. Journal of Exposure Analysis and Environmental Epidemiology, 6, 57–78.

    CAS  Google Scholar 

  • Riley, W.J., McKone, T.E., Lai, A.C.K., & Nazaroff, W.W. (2002). Indoor particulate matter of outdoor origin: Importance of size-dependent removal mechanisms. Environmental Science and Technology, 36, 200–207 & 1868.

    Article  CAS  Google Scholar 

  • Thatcher, T.L., & Nazaroff, W.W. (1997). Effect of small-scale obstructions and surface textures on particle deposition from natural convection flow. Aerosol Science and Technology, 27, 709–725.

    CAS  Google Scholar 

  • Thatcher, T.L., Lai, A.C.K., Moreno-Jackson, R., Sextro, R.G., & Nazaroff, W.W. (2002). Effects of room furnishings and airspeed on particle deposition rates indoors. Atmospheric Environment, 36, 1811–1819.

    Article  CAS  Google Scholar 

  • U.S. Environmental Protection Agency (EPA). (1997). Exposure Factors Handbook Vol.1-General Factors. EPA/600/P-95/002Fa, Washington, DC, USA.

  • Vette, A.F., Rea, A.W., Lawless, P.A., Rodes, C.E., Evans, G., Highsmith, V.R., & Sheldon, L. (2001). Characterization of indoor-outdoor aerosol concentration relationships during the Fresno PM exposure studies. Aerosol Science and Technology, 34, 118–126.

    Article  CAS  Google Scholar 

  • Wallace, L.A. Emmerich, S.J., & Howard-Reed, C. (2002). Continuous measurements of air change rates in an occupied house for 1 year: The effect of temperature, wind, fans, and windows. Journal Of Exposure Analysis and Environmental Epidemiology, 12, 296–306.

    Article  CAS  Google Scholar 

  • Xu, M.D., Nematollahi, M., Sextro, R.G., Gadgil, A.J., & Nazaroff, W.W. (1994). Deposition of tobacco-smoke particles in a low ventilation room. Aerosol Science and Technology, 20, 194–206.

    CAS  Google Scholar 

  • Zhang, J.S., Shaw, C.Y., Nguyen-Thi, L.C., MacDonald, R.A., & Kerr, G. (1995). Field measurements of boundary layer flows in ventilated rooms. Ashrae Trans, 101, Part 2, 116–124.

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. School of Mechanical and Aerospace Engineering, Nanyang Technological University, 50 Nanyang Avenue, 639798, Jurong, Singapore

    Alvin C. K. Lai

Authors
  1. Alvin C. K. Lai
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Alvin C. K. Lai.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Lai, A.C.K. Particle Deposition and Decay in a Chamber and the Implications to Exposure Assessment. Water Air Soil Pollut 175, 323–334 (2006). https://doi.org/10.1007/s11270-006-9141-y

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11270-006-9141-y

Keywords

Search

Navigation