Skip to main content

An Assessment of Mercury in the Form of Amalgam in Dental Wastewater in the United States

Abstract

An assessment was conducted of the discharge from dental facilities of mercury in the form of amalgam to surface waters in the United States. Two pathways were examined – effluent from publicly owned treatment works (POTWs) and air emissions from sewage sludge incinerators (SSIs). The annual use of mercury in the form of amalgam in the U.S. is approximately 35.2 tons (31.9 metric tons). It was estimated that 29.7 tons (26.9 metric tons) of mercury in the form of amalgam are annually discharged to the internal wastewater systems of dental facilities during amalgam placements and removals. Based on the partial capture of this amalgam in conventional chair-side traps and vacuum filters, the discharge of mercury in the form of amalgam from dental facilities to POTWs was estimated to be 6.5 tons (5.9 metric tons). The discharge of mercury to surface water via POTW effluents and SSI emissions was estimated to total approximately 0.4 tons (0.4 metric tons). A cost-effectiveness analysis determined that the annual cost to the dental industry to reduce mercury discharges through the use of amalgam separators would range from 380 millionto 1.14 billion per ton.

This is a preview of subscription content, access via your institution.

References

  • Agency for Toxic Substances and Disease Registry (ATSDR): 1999, ‘Toxicological Profile for Mercury’, Research Triangle Park, North Carolina.

  • American Dental Association (ADA): 2004, ‘Best Management Practices for Amalgam Waste’, Chicago, Illinois.

  • American Dental Association (ADA): 2002, ‘National Recruitment & Retention Report – End of Year 2001’, Chicago, Illinois.

  • American Dental Association (ADA): 2001, ‘1999 Survey of Dental Practice: Dentists in Solo and Nonsolo Practice’, Chicago, Illinois.

  • Anusavice, K. J.: 2003, Phillips’ Science of Dental Materials, WB Saunders Company, St. Louis, Missouri, 744 pp.

    Google Scholar 

  • Arenholt-Bindslev, D.: 1992, ‘Dental amalgam – environmental aspects’, Adv. Dental Res. 6, 125–130.

    Google Scholar 

  • Arenholt-Bindslev, D. and Larsen, A. H.: 1996, ‘Mercury levels and discharge in waste water from dental clinics’, Water, Air, Soil Pollut. 86, 93–99.

    Google Scholar 

  • Association of Metropolitan Sewerage Agencies (AMSA): 2002, ‘Mercury Source Control and Pollution Prevention Program’, Washington, DC.

  • Balogh, S. and Johnson, L.: 1998, ‘Mercury Mass Balances at Two Small Wastewater Treatment Plants’, Metropolitan Council Environmental Services (MCES), Minneapolis-St. Paul, Minnesota.

  • Balogh, S. and Liang, L.: 1995, ‘Mercury pathways in municipal wastewater treatment plants’, Water, Air, Soil Pollut. 80, 1181–1190.

    Google Scholar 

  • Barron, T.: 2001, ‘Mercury Headworks Analysis for 2000’, Palo Alto Regional Water Quality Control Plant, Palo Alto, California.

  • Batchu, H., Stone, M., Naleway, C. A. and Meyer, D.: 1995, ‘Comparison of particle size distributions of dental wastewater under various clinical procedures’, J. Dental Res. 74, Abstract No. 1101.

    Google Scholar 

  • Bering, C.: 1997, ‘Mercury in Dental Facilities, Massachusetts Water Resources Authority’, Massachusetts Water Resources Authority, Boston, Massachusetts.

  • Berthold, M.: 2002, ‘Restoratives: Trend data shows shift in use of materials’, Am. Dental Assoc. News 33(11), 10–11.

    Google Scholar 

  • Cailas, M. D., Ovsey, V. G., Mihailova, C., Naleway, C. A., Batchu, H., Fan, P. L., Chou, H. N., Stone, M., Meyer, D., Ralls, S. and Roddy, W.: 1994, ‘Physico-Chemical Properties of Dental Wastewater’, Water Environment Federation 67th Annual Conference & Exposition WEFTEC, Chicago, Illinois. pp. 317–327.

  • Drummond, J. L., Cailas, M. D., Ovsey, V., Stone, M., Roddy, W. C., Francis, B. M., Babka, M. A., Perry, R. P., Toepke, T. R., Cohen, M. E. and Ralls, S. A.: 1995, ‘Dental waste water: Quantification of constituent fractions’, Acad. Dental Mat. Transact. 112, P-11.

  • Fan, P. L., Arenholt-Bindslev, D., Schmalz, G., Halbach, S. and Berendson, H.: 1997, ‘Environmental issues in dentistry – mercury’, Int. Dental J. 47, 105–109.

    Google Scholar 

  • Fan, P. L., Batchu, H., Chou, H., Gasparac, W., Sandrik, J. and Meyer, D.: 2002a, ‘Amalgam in dental office wastewater: Addressing the Issue’, J. ADA 113, 585–589.

    Google Scholar 

  • Fan, P. L., Batchu, H., Gasparac, W., Sandrik, J. and Meyer, D.: 2002b, ‘Laboratory evaluation of amalgam separators’, J. ADA 113, 577–584.

    Google Scholar 

  • Florida Center for Solid and Hazardous Waste Management (CSHWM): 1997, ‘Mercury in Florida’s Medical Facilities: Issues and Alternatives, Report #S97-15’, Gainesville, Florida.

  • International Organization for Standardization (ISO): 1999, ‘Dental Equipment – Amalgam Separators, ISO 11143’, Geneva, Switzerland.

  • Johnson, B.: 2000, ‘Mercury Amalgam Treatment Technologies for Dental Offices’, Palo Alto Regional Water Quality Control Plant, Palo Alto, California.

  • Kunkel, P. K., Cook, P. M. and York, B.: 1996, ‘The fate of mercury in dental amalgam’, Water Environ. Technol. 8(12), 49–53.

    Google Scholar 

  • Massachusetts Water Resources Authority: 1997, ‘Mercury in Dental Facilities’, Boston, Massachusetts.

  • Metropolitan Council Environmental Services (MCES) and Minnesota Dental Association (MDA) 2001, ‘Evaluation of Amalgam Removal Equipment and Dental Clinic Loadings to the Sanitary Sewer’, Minneapolis-St. Paul, Minnesota.

  • Metropolitan Council Environmental Services (MCES): 1995, ‘Evaluating Sources of Mercury to the Sanitary Sewer’, Minneapolis-St. Paul, Minnesota.

  • Municipality of Metropolitan Seattle: 1993, ‘Dental Office Waste Stream Characterization Study’, Seattle, Washington.

  • Naleway, C. A., Ovsey, V., Mihailova, C., Chou, H., Fan, P. L., Whitlock, R., Meyer, D., Cailas, M., Ralls, S. A. and Cecil, J.: 1994, ‘Characteristics of amalgam in dental wastewater’, J. Dental Res. 73, Abstract No. 25.

    Google Scholar 

  • Okabe, T. B. Elvebak, L. Carrasco, J. L. Ferracane, R. G., Keanini and Nakajima, H.: 2003, ‘Mercury release from dental amalgams into continuously replenished liquids’, Dental Mat. 19(1), 38–45.

    Article  Google Scholar 

  • Rourke, D.: 1993, ‘City and County of San Francisco Dental Related Facilities – Heavy Metals Loadings’, California Water Pollution Control Association Bulletin. Fall 1993, 10–14.

  • Skare, I.: 1995, ‘Mass balance and systemic uptake of mercury released from dental amalgam fillings’, Water, Air, Soil Pollut. 80, 59–67.

    Google Scholar 

  • Stone, M. E., Pederson, E. D., Cohen, M. E., Ragain, J. C., Karaway, R. S., Auxer, R. A. and Saluta, A. R.: 2001, ‘Residual mercury content and leaching of mercury and silver from used amalgam capsules’, Acad. Dental Mat. 1, 36–37.

    Google Scholar 

  • Sznopek, J. and Goonan, T.: 2000, ‘The Materials Flow of Mercury in the Economies of the United States and the World, United States Geological Survey Circular 1197’, Denver, Colorado.

  • Tchobanoglous, G. and Burton, F. L.: 1991, Wastewater Engineering – Treatment, Disposal, and Reuse, 3rd {edn.}, Irwin McGraw-Hill, New York.

    Google Scholar 

  • United States Environmental Protection Agency (USEPA): 1999, ‘Biosolids Generation, Use, and Disposal in the U.S. EPA 530-R-99-00’, Washington, DC.

  • United States Environmental Protection Agency (USEPA): 1997, ‘Mercury Study Report to Congress EPA-452/R-97-003’, Washington, DC.

  • United States Environmental Protection Agency (USEPA): 1995, ‘Compilation of Air Pollutant Emission Factors, AP-42, Fifth Edition, Volume I: Stationary Point and Area Sources’, Washington, D.C.

  • Watson, P., Adegbembo, A. and Lugowski, S.: 2002, ‘A Study of the Fate of Mercury from the Placement and Removal of Dental Amalgam Restorations’, Royal College of Dental Surgeons, Ontario, Canada.

  • Western Lake Superior Sanitary District (WLSSD): 1992, ‘Dental Mercury Pollution Prevention Program’, Duluth, Minnesota.

  • White, E.: 2001, ‘The Ebb and Flow of Composites’, Dental Products Report, October edn., 17–21.

  • Yuming, L., Siew, C. and Shearer, B. G.: 1998, ‘Dental amalgam: Update on safety concerns’, J. Am. Dental Assoc. 129, 494–503.

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Steve L. Mcginnis.

Rights and permissions

Reprints and Permissions

About this article

Cite this article

Vandeven, J.A., Mcginnis, S.L. An Assessment of Mercury in the Form of Amalgam in Dental Wastewater in the United States. Water Air Soil Pollut 164, 349–366 (2005). https://doi.org/10.1007/s11270-005-4008-1

Download citation

  • Received:

  • Accepted:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11270-005-4008-1

Keywords

  • amalgam separator
  • biosolids
  • dental amalgam
  • dentistry
  • mercury
  • publicly owned treatment works
  • wastewater