Skip to main content
Log in

Dry sliding tribological behavior of nanocrystalline and conventional polycrystalline copper

  • Published:
Tribology Letters Aims and scope Submit manuscript

Dry sliding tribological behavior of an electro-deposited nanocrystalline Cu (nc Cu) and a conventional coarse-grained Cu (cg Cu) has been investigated using a ball-on-disc tribometer with cemented tungsten carbide ball as the counterface. Experimental results showed that the wear resistance of copper with the nanocrystalline microstructure was enhanced relative to the coarse-grained form. The steady-state friction coefficient of the nc Cu was obviously lower than that of the cg Cu when the load is below 20 N. The wear volume of the nc Cu was always lower than that of the cg Cu for the applied load range from 5 to 40 N. With increase of the load, the difference in wear resistance between the nc and the cg Cu decreased. The enhancement of the wear properties of the nc Cu was associated with the high hardness and the low work-hardening rate of the nanocrystalline structure, and easily being oxidized of wear debris, which was attributed to grain refinement.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Figure 1.
Figure 2.
Figure 3.
Figure 4.
Figure 5.
Figure 6.

Similar content being viewed by others

References

  1. Gleiter H., (1990) Phase Trans. 24: 15

    Article  Google Scholar 

  2. J.R. Weertman, D. Farkas, K. Hemker, H. Kung, M. Mayo, R. Mitra and H. Van Swygenhoven, Structure and mechanical behavior of bulk nanocrystalline materials, MRS Bulletin Feb. (1999) 44

  3. Kong X.L., Liu Y.B., Qiao L.J., (2004) Wear 256: 747

    Article  CAS  Google Scholar 

  4. Schuh C.A., Nieh T.G., Yamasaki T., (2002) Scripta Mater. 46: 735

    Article  CAS  Google Scholar 

  5. Y.S. Zhang, Z. Han, K. Wang and K. Lu, Wear (2006), in press

  6. Wang X.Y., Li D.Y., (2003) Wear 255: 836

    Article  CAS  Google Scholar 

  7. Lu L., Sui M.L., Lu K., (2000) Science 287: 1463

    Article  CAS  Google Scholar 

  8. Lu L., Wang L.B., Ding B.Z., Lu K., (2000) Mater. Sci. & Eng. A 286: 125

    Article  Google Scholar 

  9. Archard J.F., (1953) J. Appl. Phys. 24: 981

    Article  Google Scholar 

  10. Mishra R., Basu B., Balasubramaniam R., (2004) Mater. Sci. & Eng. A 73:370

    Article  CAS  Google Scholar 

  11. D.A. Rigney and J.E. Hammerberg, Unlubricated sliding behavior of metals, MRS Bulletin June (1998) 32

  12. Lu L., Sui M.L., Lu K., (2001) Acta Mater. 49: 4127

    Article  CAS  Google Scholar 

  13. Sadykov F.A., Barykin N.P., Aslanyan I.R., (1999) Wear 229: 649

    Article  Google Scholar 

  14. Lu L., Wang L.B., Ding B.Z., Lu K., (2000) J. Mater. Res. 15: 270

    Article  CAS  Google Scholar 

  15. Jeong D.H., Gonzalez F., Palumbo G., Aust K.T., Erb U., (2001) Scripta Mater. 44: 493

    Article  CAS  Google Scholar 

Download references

Acknowledgments

This work was supported by National Science Foundation of China (No. 5021101 and No. 50431010) and Ministry of Science & Technology of China (No. 2005CB623604).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Z. Han.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Han, Z., Lu, L. & Lu, K. Dry sliding tribological behavior of nanocrystalline and conventional polycrystalline copper. Tribol Lett 21, 45–50 (2006). https://doi.org/10.1007/s11249-005-9007-2

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11249-005-9007-2

Keywords

Navigation