Avoid common mistakes on your manuscript.
To the article “Assignment of the Abrasive-Jet Machining Mode of Si3N4-Ceramic Components Considering the Stress State of Various Surface-Layer Phases,” by V. V. Kuzin, M. Yu. Fedorov, and M. A. Volosova, Vol. 59, No. 4, pp. 420 – 424, November, 2018
The following Acknowledgement is to be added to page 423 after the Conclusion:
The work was financially supported by the Ministry of Education and Science of the RF under a State Task for Scientific Activity, Project No. 9.1372.2017/4.6.
Author information
Authors and Affiliations
Corresponding author
Additional information
The online version of the original article can be found at https://doi.org/10.1007/s11148-018-0247-8
Rights and permissions
About this article
Cite this article
Kuzin, V.V., Fedorov, M.Y. & Volosova, M.A. Correction to: Assignment of the Abrasive-Jet Machining Mode of Si3N4-Ceramic Components Considering the Stress State of Various Surface-Layer Phases. Refract Ind Ceram 59, 680 (2019). https://doi.org/10.1007/s11148-019-00298-x
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11148-019-00298-x