Ways of solving problems that arise in the operation of tubular scraper flight conveyors designed for hauling friable or fine abrasive materials are presented. The most frequently occurring problems are the following: seizure of the traction chain in a loaded pivoted section, wear of the branch tubes and scrapers, ingress of hauled raw material into the bridling equipment when the conveyor reverses direction, and increased noise level in the course of operation of the conveyor.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
R. L. Zenkov, Mechanics of Friable Loads [in Russian], Mashinostroenie, Moscow (1964), 252 pp.
V. G. Dmitriev and R. R. Radimov, Traction Calculation of Tubular Scraper Flight Conveyors [in Russian]. Part 2, Gorn. Inf.-Analit. Byul. Single Articles (special edition), No. 3, 16 pp.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Novye Ogneupory, No. 2, pp. 12–14, February, 2017.
Rights and permissions
About this article
Cite this article
Bespal’kov, A.A., Lukashuk, O.A. & Kozhushko, G.G. Modernization of the Units of a Tubular Scraper Flight Conveyor. Refract Ind Ceram 58, 16–18 (2017). https://doi.org/10.1007/s11148-017-0046-7
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11148-017-0046-7