Skip to main content
SpringerLink
Log in

Effect of the geometrical parameters of roll press forming elements on the briquetting process: analytical study

  • Published:
Powder Metallurgy and Metal Ceramics Aims and scope

The compaction of fine charge material in the deformation zone of a roll press is described. Analytical expressions are provided that are used to study the effect of the configuration and size of shaping elements on the power and process parameters in briquetting of fine charge material in roll presses. The calculated data show that the rational power parameters of briquetting and the desired productivity can be ensured at the stage of press equipment design by varying the configuration of shaping elements.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1

Similar content being viewed by others

References

  1. V. A. Noskov, “Mechanism of forming the deformation center in briquetting of fine charges in roll presses,” Metall. Gornorud. Prom., No. 2, 137–139 (1998).

    Google Scholar 

  2. V. A. Noskov, “Roll gripping of powder charge in briquetting,” Metall. Gornorud. Prom., No. 4, 102–104 (1997).

  3. V. A. Noskov, B. N. Maimur, V. I. Petrenko, and A. T. Lebed’, “Study of mechanical properties of fine industrial wastes determining their behavior in briquetting,” Metall. Gornorud. Prom., No. 4, 104–107 (1998).

    Google Scholar 

  4. V. A. Noskov, “Determining the energy parameters in briquetting of loose charges in roll presses,” in: Fundamental and Applied Problems of Ferrous Metallurgy (Collected Scientific Papers) [in Russian], Issue 3, Naukova Dumka, Kiev (1999), pp. 349–356.

    Google Scholar 

  5. V. A. Noskov, K. V. Bayul, and I. V. Kharun, “Study of compaction and stress-strain state of fine charges in a roll press,” Metall. Gornorud. Prom., No. 4, 142–146 (2006).

  6. K. A. Gogaev, G. Ya. Kalutskii, and V. S. Voropaev, “Asymmetric rolling of metal powders. II. Angular parameters of asymmetric rolling,” Powder Metall. Met. Ceram., 48, No. 5–6, 274–278 (2009).

Download references

Author information

Authors and Affiliations

  1. Nekrasov Institute for Ferrous Metallurgy, National Academy of Sciences of Ukraine, Dnepropetrovsk, Ukraine

    K. V. Bayul

Authors
  1. K. V. Bayul
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to K. V. Bayul.

Additional information

Translated from Poroshkovaya Metallurgiya, Vol. 51, No. 3–4 (484), pp. 38–49, 2012

Rights and permissions

Reprints and permissions

About this article

Cite this article

Bayul, K.V. Effect of the geometrical parameters of roll press forming elements on the briquetting process: analytical study. Powder Metall Met Ceram 51, 157–164 (2012). https://doi.org/10.1007/s11106-012-9411-8

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11106-012-9411-8

Keywords:

Search

Navigation