Skip to main content
Log in

Microwave absorptivity of refractory powders depending on particle size

  • Published:
Powder Metallurgy and Metal Ceramics Aims and scope

The microwave absorptivity of refractory metallic compounds at 2.45 and 9.53 GHz is studied. It is ascertained that electromagnetic absorption is influenced by the grain size of absorbing particles: when it increases by 10 times, the absorptivity of ZrC, ZrSi2, HƒC, TaN, HƒN, ZrN, and NbC particles becomes higher by a factor of 7 and that of SiC, NbSi2, WC, B4C, MoSi2, and VN particles only by a factor of 2 to 4. It is connected with the physical properties of each compound: magnetic permeability (sign and magnitude), thermal e.m.f. (sign and magnitude), and active ac resistance. It is shown that stoichiometric impurity (namely, the formation of nonmetal vacancies) increases the microwave absorptivity, while the formation of substitution phases does not change the nature of microwave interaction. It is established that the morphology of particles with the same sizes does not influence the microwave absorptivity. It is proved that the measurement of absorption in weak fields can be used for nondestructive examination of refractory metallic compounds.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. G. V. Samsonov and I. M. Vinnitskii, Refractory Compounds: Handbook [in Russian], Metallurgiya, Moscow (1976), p. 560.

    Google Scholar 

  2. G. G. Gnesin (ed.), Sintered Compounds for Electrical and Power Engineering: Handbook [in Russian], Metallurgiya, Moscow (1981), p. 344.

    Google Scholar 

  3. V. Ya. Petrovskii and V. V. Skorokhod, “Physical principles and technological aspects of the production of gradient composites based on oxygen-free ceramics,” Powder Metall. Met. Ceram., 38, No. 3–4, 115–125 (1999).

    Article  CAS  Google Scholar 

  4. D. Grossin, J.-G. Marinel, and S. Noudem, “Materials processed by indirect microwave heating in a singlemode cavity,” Ceram. Int., 32, 911–915 (2006).

    Article  CAS  Google Scholar 

  5. V. Ya. Petrovskii, G. G. Gnesin, and V. M. Kirilenko, “Dielectric characteristics of silicon nitride powders in the SFH range,” Powder Metall. Met. Ceram., 19, No. 9, 632–639 (1980).

    Article  Google Scholar 

  6. V. Petrovsky and Z. Rak, “Densification, microstructure and properties of electroconductive Si3N4–TaN composites. Part I–II,” J. Europ. Ceram. Soc., 21, 219–244 (2001).

    Article  CAS  Google Scholar 

  7. V. Petrovsky, “Electrical properties of multicomponent CMM in correlation with their microstructure,” Ceram. Int., 34, 1165–1171 (2008).

    Article  CAS  Google Scholar 

  8. S. V. Gnatenko, V. Ya. Shul’zhenko, and V. Ya. Petrovskii, “Effect of the microstructure on the effectiveness of microwave absorbers for extreme conditions,” in: Proc. 5th Int. Conf., Materials and Coatings in Extreme Conditions: Research, Application, Pollution-Free Production and Disposal of Products (September 22–26, 2008, Bol’shaya Yalta, Zhukovka, Crimea) [in Russian], Inst. Probl. Materialoved. NAN Ukrainy, Kiev (2008), p. 281.

  9. A. C. Nunes, X. Bohigas, and J. Tejada, “Dielectric study of milk for frequencies between 1 and 20 GHz,” J. Food Eng., 76, 250–255 (2006).

    Article  Google Scholar 

  10. Xavier, Roger Amigor, and Javier Tejada, “Characterization of sugar content in yoghurt by means of microwave spectroscopy,” Food Research Int., 41, 104–109 (2008).

    Article  Google Scholar 

  11. Noboru Sakai, Weijie Mao, Yukiko Koshima, and Manabu Watanabe, “A method for developing model food system in microwave heating studies,” J. Food Eng., 66, 525–531 (2005).

    Article  Google Scholar 

  12. Fa Luo, Dong-mei Zhu, and Wan-cheng Zhou, “A two-layer dielectric absorber covering a wide frequency range,” Ceram. Int., 33, 197–200 (2007).

    Article  CAS  Google Scholar 

  13. Yutsuki Nishimura and Masaki Yasuoka, “High efficiency sintering of ceramics using a domestic microwave oven,” J. Ceram. Soc. Japan, 126–129 (2004).

  14. P. Rattanadecho, “The numerical and experimental investigation of heat transport and water infiltration in granular packed beds due to supplied hot water (one-and-two-dimensional models),” Thammasat Int. J. Sc. Tech., 10, No. 3 (2005).

  15. J. G. P. Binner and B. Vaidhyanathan, “Microwave sintering of ceramics: What does it offer?” Key Eng. Mat., 725–730 (2004).

  16. Peng Zhihua, Peng Jingcui, Peng Yanfeng, et al., “Complex permittivity and microwave absorption properties of carbon nanotubes/polymer composite: A numerical study,” Phys. Let. A, 372, 3714–3718 (2008).

    Article  ADS  Google Scholar 

  17. Xian Wang, Rongzhou Gong, Peigang Li, et al., “Effects of aspect ratio and particle size on the microwave properties of Fe–Cr–Si–Al alloy flakes,” Mat. Sci. Eng. A, 466, 178–182 (2007).

    Article  Google Scholar 

  18. Haitao Zhao, Xudong Sun, and Jun Du Haitao, “Preparation and microwave-absorbing properties of NiFe2O4–polystyrene composites,” Physica B, 69–72 (2009).

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to V. Ya. Petrovskii.

Additional information

Translated from Poroshkovaya Metallurgiya, Vol. 49, No. 5–6 (473), pp. 68–83, 2010.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Shpil’ko, A.V., Kirilenko, E.V., Soltis, M.V. et al. Microwave absorptivity of refractory powders depending on particle size. Powder Metall Met Ceram 49, 304–316 (2010). https://doi.org/10.1007/s11106-010-9237-1

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11106-010-9237-1

Keywords

Navigation