Abstract
Using x-ray diffraction analysis and electron-probe microanalysis, we have studied TiC coatings obtained by chemical vapor deposition, where the base and subsequently the coating have undergone magnetic abrasive finishing. We have found that treating the base before the coating is deposited prevents an η phase (Co6W6C) from forming in the surface layer of coated platelets. Magnetic abrasive finishing (MAF) has been found to cause an α → β transition in the cobalt phase.
Similar content being viewed by others
REFERENCES
A. S. Vereshchaka, “Cutting tools with wear-resistant coatings,” Stanki and Instr., No 9, 33–40 (2000).
O. V. Stepanova and I. V. Uvarova, “Effect of magnetic-abrasive treatment on wear resistance of hard alloy inserts with diffusion coatings based on TiC,” Poroshk. Metall., Nos. 11–12, 21–28 (2002).
V. F. Loskutov, V. G. Khizhnyak, Yu. A. Kunitskii, and M. V. Kindrachuk, Diffusion Carbide Coatings [in Russian], Tekhnika, Kiev (1991).
V. E. Oliker, Powders for Magnetic-Abrasive Finishing and Wear-Resistant Coatings [in Russian], Metallurgiya, Moscow (1991).
V. I. Tret'yakov, Fundamentals of Metallography and the Technology of Producing Sintered Hard Alloys [in Russian], Metallurgiya, Moscow (1976).
G. L. Platonov, V. S. Toropchenov, R. F. Cheburaeva, and S. A. Kiryukhin, “Effect of carbon content on the cutting properties of hard alloy plates with TiC coating,” in: Hard Alloy Research [in Russian], Metallurgiya, Moscow (1991).
T. Ya. Gridasova, A. F. Zhornyak, L. A. Karpova, et al., “Optimization of MAF procedure for hard alloys,” Poroshk. Metall., No. 4, 91–96 (1982).
T. V. Loskutova, Complex Saturation of Carbon Steels and Hard Alloys with Niobium and Chromium, PhD Thesis [in Ukrainian], KPI National Technical Univ., Kiev (2004).
Author information
Authors and Affiliations
Additional information
__________
Translated from Poroshkovaya Metallurgiya, Nos. 9–10(445), pp. 49–53, September–October, 2005.
Rights and permissions
About this article
Cite this article
Stepanova, O.V., Uvarova, I.V., Smirnov, V.P. et al. Effect of Magnetic Abrasive Finishing on the Chemical and Phase Composition of TiC Coatings on VK8 Alloy. Powder Metall Met Ceram 44, 451–454 (2005). https://doi.org/10.1007/s11106-006-0008-y
Received:
Issue Date:
DOI: https://doi.org/10.1007/s11106-006-0008-y