Skip to main content
SpringerLink
Log in

High Temperature Oxidation of the Haynes 282© Nickel-Based Superalloy

  • Original Paper
  • Published:
Oxidation of Metals Aims and scope Submit manuscript

Abstract

Nickel-based superalloys are used in applications where corrosion and oxidation resistance at high temperatures are required together with microstructural stability. Superalloys with different metallurgical characteristics are therefore currently being developed; the high temperature behaviour of these systems must be evaluated. In this investigation, the isothermal oxidation resistance of a Haynes 282© nickel-based superalloy was studied by gravimetric means in the temperature range 800–1,000 °C for relatively short exposure times up to 150 h. The results from the tests suggest that the parabolic rate law describes the oxidation kinetics of the alloy. The chemical composition of the oxides present in the scale comprised an outer TiO2 layer and an inner Cr2O3 layer, with the latter located at the metal/oxide interface. In addition, the formation of an internal oxidation zone of Al2O3 and TiO2 was also observed at all temperatures. The role of oxide formation on microstructural changes experienced by the alloy is discussed.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16

Similar content being viewed by others

References

  1. E. F. Bradley, Superalloys: A Technical Guide, (ASM International, Technology and Engineering, ASM international, Materials Park, OH, 1998).

    Google Scholar 

  2. L.M. Pike, Haynes 282 alloy- a new wrought superalloy designed for improved creep strength and fabricability, Proc. ASME Turbo Expo 2006, Barcelona, Spain, May 8–11, (2006).

  3. L. M. Pike, Low-cycle fatigue behaviour of Haynes 282 and other wrought gamma-prime strengthened alloys, Proc. ASME Turbo Expo 2007: Power for Land, Sea, and Air, Vol. 5: Turbo Expo 2007, Montreal, Canada, May 14–17, (2007).

  4. L. M. Pike and S. K. Srivastava, Oxidation behaviour of wrought gamma-prime strengthened alloys. Materials Science Forum 595–598,661–671 (2008).

    Article  Google Scholar 

  5. L. M. Pike, Long Term Thermal Exposure of HAYNES 282 Alloy. Superalloy 718 and Derivatives, (Wiley, Hoboken, NJ, USA, 2010). doi:10.1002/9781118495223.ch50.

    Google Scholar 

  6. M. J. Donachie, Superalloys: A Technical Guide, 2nd ed, (ASM international, Materials Park, OH, 2002).

    Google Scholar 

  7. G. Obigodi-Ndjeng, High temperature oxidation and electrochemical investigations on nickel-base alloys, PhD thesis, Universität Erlangen-Nürnberg, Erlangen, Germany, (2011).

  8. J. H. Cheng, P. M. Rogers and J. A. Little, Oxidation behaviour of several Chromia-forming commercial Nickel-base superalloys. Oxidation of Metals 47, 381–410 (1997).

    Article  Google Scholar 

  9. T.-H. Kim, D.-H. Lee, D. Kim, C. Jung and J.-I. Yun, Analysis of oxidation behaviour of Ni-Base superalloys by laser-induced breakdown spectroscopy. Journal of Analytical Atomic Spectrometry 27, 1525–1531 (2012).

    Article  Google Scholar 

  10. Ch Jang, D. Lee and D. Kim, Oxidation behaviour of an alloy 617 in very high temperature air and helium-environments. International Journal of Pressure Vessels and Piping 85, 368–377 (2008).

    Article  Google Scholar 

  11. I. M. Edmonds, H. E. Evans, C. N. Jones and R. W. Brommfield, Intermediate temperature internal oxidation in fourth generation Ru-brearing single-crystal Nickel-base superalloys. Oxidation of Metals 69, 95–108 (2008).

    Article  Google Scholar 

  12. U. Krupp and H.-J. Christ, Selective oxidation and internal nitridation during temperature exposure of single-crystalline nickel-base superalloys. Metallurgical and Materials Transcactions 31A, 47–56 (2000).

    Article  Google Scholar 

  13. S. Giggins and F. S. Pettit, Oxidation of Ni–Cr–Al alloys between 1,000° and 1,200°C. Journal of the Electrochemical Society 118, 1782–1790 (1971).

    Article  Google Scholar 

  14. A. Sato, Y. L. Chiu and R. C. Reed, Oxidation of nickel-based single-crystal superalloys for industrial gas turbine applications. Acta Materialia 59, 225–240 (2010 ).

    Article  Google Scholar 

  15. M. H. Li, X. F. Sun, T. Jin, H. R. Guan and Z. Q. Hu, Oxidation behaviour of a single-crystal Ni-base superalloy in air II: at 1,000, 1,100 and 1,150°C. Oxidation of Metals 60, 195–210 (2003).

    Article  Google Scholar 

  16. N. Birks, G. H. Meier and F. S. Pettit, Introduction to the High Temperature Oxidation of Metals, 2nd ed, (Cambridge University Press, Cambridge, 2006).

    Book  Google Scholar 

  17. D. Young, High Temperature Oxidation and Corrosion of Metals, Elsevier Corrosion Series (1), (Elsevier, Amsterdam, 2008).

    Google Scholar 

  18. M. C. Pandey and D. V. V. Satyanarayana, “Effect of gamma prime depletion on creep behaviour of a nickel base superalloy (Inconel alloy X-750)”. Bulletin of Materials Science 19, (6), 1009–1015 (1996).

    Article  Google Scholar 

  19. J. Litz, A. Rahmel and M. Schorr, Selected carbide oxidation and internal nitridation of the Ni-base superalloy IN 738 LC and IN 939 in air. Oxidation of Metals 30, 95–105 (1988).

    Article  Google Scholar 

  20. C.D. Penna Development of new nitrided nickel-base alloys for high temperature applications, TMS Superalloys, The Minerals, Metals & Materials Society (Warrendale, PA, 2000), pp. 821–828.

  21. C. Soontrapa, Modeling stress accelerated grain boundary oxidation (SAGBO) in INCOLOY 718, (2005).

  22. R. C. Reed, The superalloys. Fundamentals and Applications, (Cambridge University Press, Cambridge, 2006).

    Book  Google Scholar 

  23. J. Smialek and G. Meier, Superalloys II, Chapter 11, 1st Edition ed, (Wiley Interscience, New York, 1987).

    Google Scholar 

  24. V. O. Agaltsova, N. V. Kolyasnikova and S. A. Golovanenko, Effect of alloying elements on the properties of corrosion-resistant high-temperature single-crystal alloys on a nickel base. Materials Science and Heat Treatment 40, 97–99 (1998).

    Article  Google Scholar 

Download references

Acknowledgments

The authors would like to thank National Council for Science and Technology in Mexico (CONACYT), the program for the Formation and Development of Academic Staff (PROMEP) and the Science and Technology Program of Universidad Autónoma de Nuevo Leon (PAICYT UANL) for the support provided for the development of this investigation.

Author information

Authors and Affiliations

  1. Facultad de Ingeniería Mecánica y Eléctrica, Universidad Autónoma de Nuevo León, San Nicolás de los Garza, Nuevo León, Mexico

    F. A. Pérez-González, N. F. Garza-Montes-de Oca & R. Colás

  2. Centro de Innovación, Investigación y Desarrollo en Ingeniería y Tecnología, Universidad Autónoma de Nuevo León, San Nicolás de los Garza, Nuevo León, Mexico

    F. A. Pérez-González & N. F. Garza-Montes-de Oca

Authors
  1. F. A. Pérez-González
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. N. F. Garza-Montes-de Oca
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. R. Colás
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to N. F. Garza-Montes-de Oca.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Pérez-González, F.A., Garza-Montes-de Oca, N.F. & Colás, R. High Temperature Oxidation of the Haynes 282© Nickel-Based Superalloy. Oxid Met 82, 145–161 (2014). https://doi.org/10.1007/s11085-014-9483-6

Download citation

  • Received:

  • Revised:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11085-014-9483-6

Keywords

Search

Navigation