Abstract
Vortex-induced vibrations are one of the major factors in fatigue failure of power transmission lines and can be mitigated using vibration absorbers in the form of Stockbridge dampers. Since power transmission lines play an important role in modern infrastructure, a thorough understanding of the nonlinear dynamical interactions between conductors, dampers, and wind forces is crucial. Although different nonlinear models exist for conductor vibration with attached dampers or under wind force, no work combines all these nonlinearities in a single model and examines the dynamics of the conductor along with dampers. In an attempt to fill this gap, this work combines the nonlinearities from the mid-plane stretching of the conductor, equivalent cubic stiffness of the Stockbridge damper, and fluctuating lift force modeled as a Van der Pol oscillator in a single model to investigate the nonlinear vortex-induced vibrations. In this work, the conductor is modeled as a simply supported beam and the Stockbridge damper as a mass–spring–damper–mass system with a combination of cubic and linear stiffness. The governing equations of motion are solved analytically using the method of multiple scales for the case of primary resonance between the fluctuating lift-force and conductor. Analytical findings are further validated by comparing against the numerical integration of a reduced-order system, and the results show an excellent match. The analysis is extended by conducting a parametric study to investigate the effect of different system parameters on the frequency response curves. These findings are promising and further provide a direction to design an optimal vibration absorber.
This is a preview of subscription content, access via your institution.

















References
Skop, R.A., Balasubramanian, S.: A new twist on an old model for vortex-excited vibrations. J. Fluids Struct. 11(4), 395–412 (1997)
Benedettini, F., Rega, G.: Non-linear dynamics of an elastic cable under planar excitation. Int. J. Non-Linear Mech. 22(6), 497–509 (1987)
Chan, J., et al.: EPRI Transmission Line Reference Book: Wind-Induced Conductor Motion. Electric Power Research Institute, Palo Alto, CA (2009)
Barry, O., Zu, J.W., Oguamanam, D.C.D.: Analytical and experimental investigation of overhead transmission line vibration. J. Vib. Control 21(14), 2825–2837 (2015)
Barry, O., Oguamanam, D.C., Lin, D.C.: Aeolian vibration of a single conductor with a stockbridge damper. In Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, pp. 935–945. Institution of Mechanical Engineers (2013)
Barry, O., Long, R., Oguamanam, D.C.: Simplified vibration model and analysis of a single-conductor transmission line with dampers. In: Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Vol. 231, pp. 4150–4162. Institution of Mechanical Engineers, New York (2016)
Barry, O., Zu, J.W., Oguamanam, D.C.D.: Forced vibration of overhead transmission line: analytical and experimental investigation. J. Vib. Acoust. 136, 4 (2014)
Oliveira, A.R.E., Freire, D.G.: Dynamical modelling and analysis of aeolian vibrations of single conductors. IEEE Trans. Power Deliv. 9(3), 1685–1693 (1994)
Verma, H., Hagedorn, P.: Wind induced vibrations of long electrical overhead transmission line spans: a modified approach. Wind Struct. 8(2), 89–106 (2005)
Schäfer, B.: Dynamical modelling of wind-induced vibrations of overhead lines. Int. J. Non-Linear Mech. 19(5), 455–467 (1984)
Kraus, M., Hagedorn, P.: Aeolian vibrations: wind energy input evaluated from measurements on an energized transmission line. IEEE Trans. Power Deliv. 6(3), 1264–1270 (1991)
Nigol, O., Houston, H.J.: Aeolian vibration of single conductor and its control. IEEE Trans. Power Deliv. 104(11), 3245–3254 (1985)
Tompkins, J.S., Merill, L.L., Jones, B.L.: Quantitative relationships in conductor vibration using rigid models. IEEE Trans. Power Apparat. Syst. 75(11), 879–894 (1956)
Rawlins, C.B.: Recent developments in conductor vibration. Alcoa Technical Paper No. 13 (1958)
Hardy, C., Noiseux, D.U.: Modeling of a Single Conductor-Damper System Response, vol 1. Theoretical and Validation Manual. CEA, Hydro (1996)
Noiseux, D.U., Hardy, C., Houle, S.: Statistical methods applied to aeolian vibration of overhead conductors. J. Sound Vib. 113(2), 245–255 (1987)
Tsui, Y.T.: Recent advances in engineering science as applied to aeolian vibrations an alternative approach. Electr. Power Syst. Res. 5, 73–85 (1982)
Dowell, E.H.: Component mode analysis of nonlinear and nonconservative systems. J. Appl. Mech. 47(1), 172–176 (1980)
Pakdemirli, M., Nayfeh, A.H.: Nonlinear vibrations of a beam-spring-mass system. J. Vib. Acoust. 116(4), 433–439 (1994)
Barry, O., Oguamanam, D.C.D., Zu, J.W.: Nonlinear vibration of an axially loaded beam carrying multiple mass-spring-damper systems. Nonlinear Dyn. 77, 1597–1608 (2014)
Bukhari, M., Barry, O.: Nonlinear vibrations analysis of overhead power lines: a beam with mass-spring-damper-mass systems. J. Vib. Acoust. 140(3) (2017)
Khan, N.S., Islam, S., Gul, T., Khan, W., Khan, I., Ali, L., Khan, N., Waris, K., Als, L.: Thin film flow of a second grade fluid in a porous medium past a stretching sheet with heat transfer. Alexandria Eng. J. 57, 1019–1031 (2017)
Khan, N.S., Gul, T., Islam, S., Khan, I., Alqahtani, A.M., Alshomrani, A.S.: Magnetohydrodynamic nanoliquid thin film sprayed on a stretching cylinder with heat transfer. Appl. Sci. 7, 271 (2017)
Khan, I., Shafie, S.: Rotating mhd flow of a generalized burgers’ fluid over an oscillating plate embedded in a porous medium. Thermal Sci. 19, 183–190 (2015)
Zuhra, S., Khan, N.S., Khan, M., Islam, S., Khan, W., Bonyah, E.: Flow and heat transfer in water based liquid film fluids dispensed with graphene nanoparticles. Results Phys. 8, 1143–1157 (2018)
Khan, N.S., Gul, T., Khan, M.A., Bonyah, E., Islam, S.: Mixed convection in gravity-driven thin film non-newtonian nanofluids flow with gyrotactic microorganisms. Results Phys. 7, 4033–4049 (2017)
Morkovin, M.V.: Flow around circular cylinders. a caleidoscope of challenging fluid phenomena. In: ASME Symposium on Fully Separated Flows, Philadelphia, PA, pp. 102–118 (1964)
Marris, A.W.: A review on vortex streets, periodic wakes, and induced vibration phenomena. ASME J. Basic Eng. 86, 185–196 (1964)
Mair, W.A., Maull, D.J.: Bluff bodies and vortex shedding–a report on euromech 17. J. Fluid Mech. 45, 209–224 (1971)
Hartlen, R.T., Currie, I.G.: Lift-oscillator model of vortex-induced vibration. J. Eng. Mech. Div. 96(5), 577–591 (1970)
Skop, R.A., Griffin, O.M.: A model for the vortex-excited resonant response of bluff cylinders. J. Sound Vib. 27(2), 225–233 (1973)
Iwan, W.D., Blevins, R.D.: A model for vortex induced oscillation of structures. J. Appl. Mech. 41(3), 581–586 (1974)
Skop, R.A., Griffin, O.M.: On a theory for the vortex-excited oscillations of flexible cylindrical structures. J. Sound Vib. 41, 263–274 (1974)
Iwan, W.D.: The vortex induced oscillation of elastic structural elements. ASME J. Eng. Ind. 97, 1378–1382 (1975)
Williamson, C.H.K., Govardhan, R.: Vortex-induced vibrations. Annu. Rev. Fluid Mech. 36, 413–455 (2004)
Kim, W.-J., Perkins, N.C.: Two-dimensional vortex-induced vibration of cable suspensions. J. Fluids Struct. 16(2), 229–245 (2002)
Facchinetti, M.L., de Langre, E., Biolley, F.: Coupling of structure and wake oscillators in vortex-induced vibrations. J. Fluids Struct. 19(3), 123–140 (2004)
Govardhan, R., Williamson, C.H.K.: Modes of vortex formation and frequency response of a freely vibrating cylinder. J. Fluid Mech. 420, 85130 (2000)
Norberg, C.: Fluctuating lift on a circular cylinder: review and new measurements. J. Fluids Struct. 17(1), 57–96 (2003)
Sarpakaya, T.: Vortex-induced oscillations: a selective review. J. Appl. Mech. 46, 241–258 (1979)
Griffin, O.M., Ramberg, S.E.: Some recent studies of vortex shedding with application to marine tubulars and risers. ASME J. Energy Resour. Technol. 104, 2–13 (1982)
Parkinson, G.: Phenomena and modeling of flow-induced vibrations of bluff bodies. Prog. Aerosp. Sci. 26, 169–224 (1989)
Pantazopoulos, M.S.: Vortex-induced vibration parameters: critical review. Proc. Int. Conf. Offshore Mech. Arct. Eng. 1, 199–255 (1994)
Nayfeh, A.H., Mook, D.T.: Nonlinear Oscillations. Wiley, New York (2008)
Wu, J.-S., Chou, H.-M.: Free vibration analysis of a cantilever beam carrying any number of elastically mounted point masses with the analytical-and-numerical-combined method. J. Sound Vib. 213(2), 317–332 (1998)
Ramberg, S.E., Griffin, O.M.: Vortex formation in the wake of a vibrating, flexible cable. ASME J. Fluids Eng 96, 317–322 (1974)
Ramberg, S.E., Griffin, O.M.: Velocity correlation and vortex spacing in the wake of a vibrating cable. ASME J. Fluids Eng. 99, 10–18 (1976)
Nayfeh, A.H.: Introduction to Perturbation Techniques. Wiley, New York (1981)
Acknowledgements
This work was funded by National Science Foundation CAREER Award ECCS #1944032. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the author(s) and do not necessarily reflect the views of the National Science Foundation.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
The authors declare that they have no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Appendix A: Expressions used in Eq. (34)
Appendix A: Expressions used in Eq. (34)
For the sake of simplicity, slow flow equations (Eq (33)), governing the amplitude and phase, can be written in a more compact form as
where \(A_{ij}\) (for \(i=1,\,2,\,3\) and \(j=1,\,2,\,3\)) and \(B_{ij}\) (for \(i=1,\,2,\,3\) and \(j=1,\,2,\,3,\,4\)) are the function of system parameters, excitation frequency, and amplitudes \(a_y\) and \(q_y\). These are given by
As mentioned in the main text, the steady state amplitudes and phase can be obtained by setting \(D_2 a_y=D_2 q_y=D_2\Gamma =0\), which further leads to
In the above equation, superscript \(^{*}\) refers to steady state quantities. Equations (41a) and (41b) can be solved for \(\sin (\Gamma ^{*})\) and \(\cos (\Gamma ^{*})\) to get
In the next step, by using trigonometric identity, and substituting Eq. (42) in Eq. (41c), we get two algebraic equations in the form of
Note that in the above equations except \(a^{*}_y\) and \(q^{*}_y\) all the system and excitation parameters are known, hence, these simultaneous algebraic equations can be used to govern the steady state amplitudes \(a^{*}_y\) and \(q^{*}_y\) and can be written in a compact form as
Rights and permissions
About this article
Cite this article
Gupta, S.K., Malla, A.L. & Barry, O.R. Nonlinear vibration analysis of vortex-induced vibrations in overhead power lines with nonlinear vibration absorbers. Nonlinear Dyn 103, 27–47 (2021). https://doi.org/10.1007/s11071-020-06100-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11071-020-06100-9
Keywords
- Nonlinear vibration
- The method of multiple scale
- Wake oscillator