Skip to main content
SpringerLink
Log in

Dispersion of nano-silicon carbide (SiC) powder in aqueous suspensions

  • Published:
Journal of Nanoparticle Research Aims and scope Submit manuscript

Abstract

The dispersion characteristics of nanosize silicon carbide (SiC) suspension were investigated in terms of surface charge, particle size, rheological measurement and adsorption study. Ammonium polycarboxylate has been used as dispersant to stabilize the suspension. It was found that the isoelectric point (iep) of SiC powder was pHiep (4.9). The surface charge of powder changed significantly in presence of the ammonium polycarboxylate dispersant and iep shifted significantly towards lower acidic pH (3.6). The shift in iep has been quantified in terms of ΔG 0 SP, the specific free energy of adsorption between the surface sites and the adsorbing polyelectrolyte (APC). The values of ΔG 0 SP (−10.85 RT unit) estimated by the electro kinetic data compare well with those obtained from adsorption isotherms (−9.521 RT unit). The experimentally determined optimum concentration of dispersant required for maximizing the dispersion was found to be 2.4 mg/g of SiC (corresponding to an adsorbed amount of 1.10 mg/g), at pH 7.5. This is much below the full monolayer coverage (corresponding to adsorbed amount of 1.75 mg/g) of the particles surface by the dispersant. The surface charge quantity, rheological, pH, electro kinetic and adsorption isotherm results were used to explain and correlate the stability of the nanosize silicon carbide in aqueous media. At pH 7.5, where both SiC surface and APC are negatively charged, the adsorption of APC was low because of limited availability of favourable adsorption sites. In addition, the brush-like configuration of the adsorbed polymer prevented close approach of any additional dispersant; hence stabilization of the slurry happens at a comparatively lower concentration than the monolayer coverage.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  • Besra L., 2002. Some studies on flocculation and dewatering of kaolin suspensions by polyacrylamides in presence of some surfactants. Ph.D. Thesis, IIT Kharagpur, India

  • Besra L., Sengupta D.K., Singh B.P., Bhattacharjee S. (2005) A novel method based on capillary suction time (CST) for assessment of dispersion characteristics of suspensions. J. Am. Ceram. Soc. 88:109–115

    Article  CAS  Google Scholar 

  • Bowen P., Carry C., Luxembourg D., Hofmann H. (2005) Colloidal processing and sintering of nanosized transition aluminas. Powder Technol. 157:100–107

    Article  CAS  Google Scholar 

  • Brinker J (2004) Technology for improving human performance. MRS Bull. 29:631–640

    CAS  Google Scholar 

  • Bhattacharjee S., Singh B.P., Besra L., Sengupta D.K. (2005) Performance evaluation of dispersants through streaming potential measurements. J. Disp. Sci. Technol. 26:365–370

    CAS  Google Scholar 

  • Cohen stuart M.A., Fleer G.J., Lyklema J., Norde W, Scheutjens J.M.H.M. (1991) Adsorption of ions, polyelectrolytes and proteins. Adv. Colloid Interface Sci. 34:477–535

    Article  Google Scholar 

  • Davies J., Binner J.G.P. (2000) The role of ammonium polyelectrolyte in dispersing concentrated alumina suspensions. J. Eur. Ceram. Soc. 20:1539–1553

    Article  CAS  Google Scholar 

  • Giles C.H., MacEwan T.H., Nkaw S.N., Smith D. (1960) Studies in adsorption, Part XI. A system of classification of solution adsorption isotherms and its use in diagnosis of adsorption mechanism and in measurement of specific surface. J. Chem. Soc. 110:3973–3993

    Article  Google Scholar 

  • Hackley V.A. (1997) Colloidal processing of silicon carbide with poly(acrylic acid): I, adsorption and electrostatic interaction. J. Am. Ceram. Soc. 80:2315–2325

    Article  CAS  Google Scholar 

  • Hackley V.A., Paik U., Kim B.H., Malghan S.G. (1997) Aqueous processing of sintered reaction bonded silicon carbide; I dispersion properties of silicon carbide powder. J. Am. Ceram. Soc. 80:1781–1788

    Article  CAS  Google Scholar 

  • Hackley V.A., Malaghan S.G. (1994) The surface chemistry of silicon nitride powder in the presence of dissolved ions. J. Mater. Sci 29:4420–4430

    Article  CAS  Google Scholar 

  • Kirby G.H., Haris D.J., Li Q., Lewis J.A. (2004) PAA–PEO combo polymer dispersants for colloidal processing. J. Am. Ceram. Soc. 87:181–186

    Article  CAS  Google Scholar 

  • Nitzsche R. & L. Bley, 1997. Particle Charge Detector – a New Method to Characterize and Optimise the Processing of Ceramics. Operating Manual. Mütek, Herrsching, Germany

  • Pradip, B. Rai & P. Sathish, 2004. Rational design of dispersants by molecular modeling for advanced ceramic processing applications. KONA 2, 151–158

  • Pradip, Premachandran R.S., Malghan S.G. (1994) Electrokinetic behaviour and dispersion characteristics of ceramic powders with cationic and anionic polyelectrolytes. Bull. Mater. Sci. 17:911–920

    CAS  Google Scholar 

  • Pradip (1988) On the interpretation of electrokinetic behaviour of chemisorbing surfactant systems. Trans. Ind. Inst. Metal 41:15–23

    Google Scholar 

  • Pradip, Fuerstenau D.W. (1983) The adsorption of hydroxamate on semi-soluble minerals: Part I: Adsorption on barite, calcite and bastnaesite. Colloid Surfaces 8:103–119

    Article  CAS  Google Scholar 

  • Pugh R.J. (1994) Dispersion and stability of ceramic powders in liquid. In: Pugh R.J., Bergstrom L. (eds) Surface and Colloid Chemistry in Advanced Ceramics Processing. Marcel Dekker, New York, pp 127–192

    Google Scholar 

  • Ramachandra Rao R., Roopa H.N., Kannan T.S. (1999) Effect of pH on the dispersibility of silicon carbide powders in aqueous media. Ceram. Int. 25:223–230

    Article  Google Scholar 

  • Seal S., Kuiry S.C., Georgieva P., Agarwal A. (2004) Making nanocomposite components: Present status and future challenges. MRS Bull. 29:6–21

    Google Scholar 

  • Singh B.P., Menchavez R., Takai C., Fuji M., Takahashi M. (2005) Stability of dispersions of colloidal alumina particles in aqueous suspension. J. Colloid Interface Sci. 291:169–174

    Article  CAS  Google Scholar 

  • Singh B.P., Bhattacharjee S., Besra L., Sengupta D.K. (2002) Comparison between techniques based on charge characterization and capillary suction time for assessing the dispersion characteristics of concentrated slurry. J. Mater. Sci. 39:2437–2442

    Article  Google Scholar 

  • Singh B.P., Besra L., Bhattacharjee S. (2002) Factorial design of experiments on the effect of surface charges on stability of aqueous colloidal ceramic suspension, Colloid Surf A 204:175–181

    Article  CAS  Google Scholar 

  • Singh B.P, Bhattacharjee S., Besra L., Sengupta D.K. (2004) Evaluation of dispersibility of aqueous alumina suspension in presence of Darvan C. Ceram. Int. 30:939–946

    Article  CAS  Google Scholar 

  • Somasundaran P., Yu X. (1996) Dispersions: progress prospects. Powder Technol. 88:305–307

    Article  CAS  Google Scholar 

  • Subbanna M., Kapur P.C., Pradip (2002) Role of powder size, pac king, solid loading and dispersion in colloidal processing of ceramics. Ceram. Int. 28:401–405

    Article  CAS  Google Scholar 

  • Thayer A.M., 2000. Firms find a new field of dreams. Special Report, 78, 36–38

    Google Scholar 

  • Zhou L.J., Huang Y., Xie Z.P., Cheng Y.B. (2000) Gas discharging reaction and their effect on the microstructure of green bodies in gelcasting of non oxide materials. Mater. Lett. 45:51–57

    Article  CAS  Google Scholar 

  • Zhou Z., Scales P.J., Boger D.V. (2001) Chemical and physical control of the rheology of concentrated metal oxide suspensions. Chem. Eng. Sci. 56:2901–2920

    Article  CAS  Google Scholar 

Download references

Acknowledgements

The authors are thankful to the Director, Regional Research Laboratory, Bhubaneswar, for his kind permission to publish this paper. The authors are also equally thankful to Prof. Minoru Takahashi, Ceramic Research Laboratory, Nagoya Institute of Technology, Nagoya, Japan for kindly providing nano-SiC powder.

Author information

Authors and Affiliations

  1. Colloids & Materials Chemistry Group, Regional Research Laboratory (Council of Scientific & Industrial Research), Bhubaneswaer, 751013, India

    Bimal P. Singh, Jayadev Jena, Laxmidhar Besra & Sarama Bhattacharjee

Authors
  1. Bimal P. Singh
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Jayadev Jena
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Laxmidhar Besra
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Sarama Bhattacharjee
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Bimal P. Singh.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Singh, B.P., Jena, J., Besra, L. et al. Dispersion of nano-silicon carbide (SiC) powder in aqueous suspensions. J Nanopart Res 9, 797–806 (2007). https://doi.org/10.1007/s11051-006-9121-6

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11051-006-9121-6

Keywords

Search

Navigation