Mathematical simulation is used to develop modes of vacuum carburizing providing the specified level of operating properties in high-load gears from steel VKS-7. The computed values of the operating properties are compared to experimental data obtained by testing check pieces subjected to vacuum carburizing by the modes developed.
Similar content being viewed by others
References
Yu. S. Eliseev, V. V. Krymov, N. M. Ryzhov, et al., Production of Gears of Gas Turbine Engines [in Russian], Vysshaya Shkola, Moscow (2001), 493 p.
N. M. Ryzhov, A. E. Smirnov, and R. S. Fakhurtdinov, “Cyclic strength of steel 16Kh3NVFMB (VKS-5) after vacuum carburizing,” Metalloved. Term. Obrab. Met., No. 2, 23 – 28 (2010).
M. Yu. Semenov, I. N. Gavrilin, and M. Yu. Ryzhov, “Analysis of the methods of hardening of gears from heat-resistant steels on the basis of a computational method,” Metalloved. Term. Obrab. Met., No. 1, 42 – 46 (2014).
M. Yu. Semenov, “Control of the structure of carburized layers of heat-resistant steels. Part 1,” Metalloved. Term. Obrab. Met., No. 5, 31 – 38 (2013).
M. M. Saverin, Contact Strength of Materials under Joint Action of Normal and Tangential Loads (TsNIITMASh, Book 2) [in Russian], Mashgiz, Moscow – Leningrad (1946), 148 p.
M. S. Eidinov, Design of Gears and Worm Drives [in Russian], Mashgiz, Moscow – Sverdlovsk (1961), 216 p.
M. Yu. Semenov, “Computational evaluation of the cyclic strength of carburized gears from heat-resistant steels,” Metalloved. Term. Obrab. Met., No. 8, 28 – 33 (2014).
R. Herzberg, Deformation and Fracture Mechanics of Structural Materials [Russian translation], Metallurgiya, Moscow (1989), 576 p.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 1, pp. 27 – 30, January, 2015.
Rights and permissions
About this article
Cite this article
Semenov, M.Y., Smirnov, A.E., Fakhurtdinov, R.S. et al. Optimization of Modes of Vacuum Carburizing of Gears from Heat-Resistant Steel VKS-7 on the Basis of Computational Design. Met Sci Heat Treat 57, 28–31 (2015). https://doi.org/10.1007/s11041-015-9829-y
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11041-015-9829-y