A method of calculating residual stresses that arise in solid or hollow cylinders following thermochemical treatment is considered. Computer calculations are performed by means of the ANSYS program.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Ya. D. Vishnyakov and V. D. Piskarev, Management of Residual Stresses in Metals and Alloys [in Russian], Metallurgiya, Moscow (1989), 254 p.
K. A. Basov, ANSYS in Examples and Problems [in Russian], Komp’yuter Press, Moscow (2002), 224 p.
O. M. Ogorodnikova, Structural Analysis in the ANSYS Environment [in Russian], UGTU, Ekaterinburg (2004).
A. B. Kaplun, E. M. Morozov, and M. A. Olfer’eva, ANSYS in the Hands of the Engineer. Practical Manual [in Russian], URSS, Moscow (2003), 272 p.
K. A. Basov, The Graphics Interface of the ANSYS Complex [in Russian], DMK Press, Moscow (2006), 248 p.
S. I. Karatushin, D. V. Spiridinov, and Yu. A. Pleshanova, “Simulation of residual stresses in the process of casehardening,” Izv. Vysh. Ucheb. Zaved., Mashinostroenie, No. 3, 49 – 52 (2012).
I. A. Kazakovtsev and S. M. Shlyakhov, “Estimation of stressstrain state of a hollow shaft casehardened along the contour with lengthwise varying casehardening,” Izv. Vysh. Ucheb. Zaved., Mashinostroenie, No. 3, 33 – 40 (2008).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 6, pp. 53 – 55, June, 2013.
Rights and permissions
About this article
Cite this article
Karatushin, S.I., Spiridonov, D.V. & Pleshanova, Y.A. Residual Stresses in Cylindrical Articles. Met Sci Heat Treat 55, 339–341 (2013). https://doi.org/10.1007/s11041-013-9631-7
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11041-013-9631-7