Hardening of steel after induction surface heating is studied. Amodel of the process of hardening of a cylinder is created and subjected to numerical simulation in order to determine the stresses formed in the part. Two principal methods for describing the variation of the stress state during the treatment are developed. Residual stresses are analyzed in both models and compared with the results of an x-ray study. The correlation between the measured data and the numerical results is discussed.
Similar content being viewed by others
References
S. Dénis, “Modélisation des interactions contraintes-transformation de phases et calcul par éléments finis de la genèse des contraintes internes au cours de la trempe des aciers,” Thèse de Doctorat ès Sciences Physiques de l’INPL (1987).
C. Durban, “Analyse et optimisation des paramètres influents sur le calcul prévisionnel des contraintes résiduelles consécutives au chauffage superficiel par induction suivi d’une trempe,” Thèse de Doctorat ENSAM Bordeaux (1997).
E. Barrère, “Contribution à la modélisation des contraintes résiduelles lors de la trempe superficielle au défilé aprés un chauffage par induction,” Thèse de Doctorat ENSAM Bordeaux (1992).
J. Giusti, Analysis of Thermal Stress including metallurgical effects I.R.S.I.D, Rapport RE1030, Sept. (1983).
O. Longeot, D. Durand, and J. L. Leburn, “Characterization test for induction heat treatment. Application to C42 and 42Cr2 steels,” in: Proc. 6th Int. Congr. on Heat Treatment of Materials, Chicago, ASM Intern., Sept. (1988), pp. 143 – 150.
M. Kchaou, “Contribution à la prédétermination des états structuraux et des contraintes résiduelles aprés trempe superficielle par induction,” Thèse de Doctorat l’ENSAM Bordeaux, janvier (1995).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 4, pp. 18 – 23, April, 2010.
Rights and permissions
About this article
Cite this article
Kchaou, M., Durand, D. & Dammak, F. Superficial quenching of mechanical pieces and calculation of residual stresses: modeling and simulation. Met Sci Heat Treat 52, 157–162 (2010). https://doi.org/10.1007/s11041-010-9247-0
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11041-010-9247-0