The effect of conditions of fabrication of Co57Fe5Ni10Si11B17 amorphous ribbons on their magnetic properties is determined. An algorithm for computing the process parameters for making amorphous ribbons with specified thickness is suggested.
Similar content being viewed by others
References
V. Kislov, Yu. Levin, and A. Serebryakov, “Structure and deformation induced magnetic anisotropy of amorphous alloys,” Suppl. Trans. JIM, 29, 387 – 390 (1988).
H. C. Hilzinger and S. Hock, “Preparation of metallic glasses,” in: Conf. on Metallic Glasses, Budapest, 1980 (1981), Vol. 1, pp. 71 – 90.
Yu. B. Levin, “A model of the process of formation of amorphous ribbon due to hardening of a flat stream of melt,” Metalloved. Term. Obrab. Met., No. 3, 46 – 49 (2009).
Author information
Authors and Affiliations
Additional information
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 10, pp. 28 – 31, October, 2009.
Rights and permissions
About this article
Cite this article
Levin, Y.B. Fabrication of amorphous ribbons with a specified level of magnetic properties by hardening a planar stream of melt. Met Sci Heat Treat 51, 486–489 (2009). https://doi.org/10.1007/s11041-010-9198-5
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11041-010-9198-5