Skip to main content
SpringerLink
Log in

Structure and properties of alloys and coatings with ordered β-phase after heat treatment

  • Heat and Chemicothermal Treatment
  • Published:
Metal Science and Heat Treatment Aims and scope

Abstract

Ways for changing the structure and properties of alloys of the Cu-Zn-Fe-Mn-Si system due to formation of required amount of CuZn ordered β-phase with specific grain size during heat treatment and for raising the endurance of alloys of the Fe-Cr-Al system due to formation of ordered DO 3 -or B2-phases in the α-solid solution during aluminizing are considered. The effect of the composition of alumosilicide β-coatings on their protective properties is analyzed, including their resistance to cracking upon rapid cooling. The effect of boron on the endurance of such coatings is studied.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. V. G. Vaks, “Ordering alloys: structures, phase transformations, and strength,” Soros Obraz. Zh., No. 3, 115–123 (1997).

  2. Ordering of Atoms and Its Effect on the Properties of Alloys, Resp. Mezhved. Sb. Akad. Nauk, Ser. Metallofiz. [in Russian], Issue 20, Naukova Dumka, Kiev (1968).

  3. M. I. Gol’dshtein, V. S. Litvinov, and B. M. Bronfin, Physical Metallurgy of High-Strength Alloys [in Russian], Metallurgiya, Moscow (1986).

    Google Scholar 

  4. B. A. Grinberg and M. A. Ivanov, Ni 3 Al and Ti 3 Al Intermetallics: Microstructure and Deformation Behavior [in Russian], UrO RAN, Ekaterinburg (2002).

    Google Scholar 

  5. P. T. Kolomytsev, Refractory Diffusion Coatings [in Russian], Metallurgiya, Moscow (1979).

    Google Scholar 

  6. A. P. Smirnyagin, N. A. Smirnyagina, and A. V. Belova, Commercial Nonferrous Metals and Alloys [in Russian], Metallurgiya, Moscow (1974).

    Google Scholar 

  7. V. D. Turkin and M. V. Rumyantsev, Structure and Properties of Nonferrous Metals [in Russian], Metallurgizdat, Moscow (1947).

    Google Scholar 

  8. M. V. Mal’tsev, Metallography of Industrial Nonferrous Metals and Alloys (with an Atlas of Macro-and Microstructures) [in Russian], Metallurgiya, Moscow (1979).

    Google Scholar 

  9. A. A. Presnyakov, V. V. Chervyakova, U. K. Duisemaliev, and A. V. Novikov, Brasses: Solid-State Transformations and Process Properties [in Russian], Metallurgiya, Moscow (1969).

    Google Scholar 

  10. O. A. Bannykh, P. B. Budberg, S. P. Alisova, et al., Phase Diagrams of Binary and Multicomponent Systems Based on Iron [in Russian], Metallurgiya, Moscow (1986).

    Google Scholar 

  11. O. Kubashevski, Phase Diagrams of Iron-Base Binary Systems [Russian translation], Metallurgiya, Moscow (1985).

    Google Scholar 

  12. B. A. Kolachev, A. A. Ilyin, and P. D. Drozdov, “Composition, structure, and mechanical properties of binary intermetallics,” Izv. Vuzov, Tsvetn. Met., No. 6, 41–52 (1997).

  13. N. S. Stoloff and R. G. Davies, Mechanical Properties of Ordering Alloys [Russian translation], Metallurgiya, Moscow (1969).

    Google Scholar 

  14. B. A. Movchan and I. S. Malashenko, Refractory Coatings Deposited in Vacuum [in Russian], Naukova Dumka, Kiev (1983).

    Google Scholar 

  15. V. I. Nikitin, “Use of coatings for protecting gas turbine blades from sulfide-oxide corrosion: a review,” Énergomashinostroenie, No. 2, 41–44 (1980).

  16. B. N. Guzanov, S. V. Kositsyn, and N. B. Pugacheva, Reinforcing Protective Coatings in Mechanical Engineering [in Russian], URO RAN, Ekaterinburg (2004).

    Google Scholar 

  17. I. I. Kornilov, Ferrous Alloys. Iron-Chromium-Aluminum Alloys [in Russian], Vol. 2, Izd. Akad. Nauk SSSR, Moscow-Leningrad (1945).

    Google Scholar 

  18. W. C. Oliver and G. M. Phar, “An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments,” J. Mater. Res., 7(6), 1554–1583 (1992).

    Article  Google Scholar 

  19. S. I. Bulychev, “Relation between recovered and unrecovered hardness in a nanomicroindentation test,” Zh. Tekh. Fiz., 69(7), 42–48 (1999).

    Google Scholar 

  20. N. B. Pugacheva, A. V. Tropotov, S. V. Smirnov, and O. S. Kuz’min, “Effect of iron content in alloyed brass LMtsAZhKS on the composition and morphology of (Fe, Mn)5Si3 silicides,” Fiz. Met. Metalloved., 89(1), 62–69 (2000).

    CAS  Google Scholar 

  21. N. B. Pugacheva, E. O. Ékzemplyarova, and S. M. Zadvorkin, “Effect of aluminum on physicomechanical properties of Fe-Cr-Al alloys,” Metally, No. 1, 43–57 (2006).

  22. P. T. Kolomytsev, Gas Corrosion and Strength of Nickel Alloys [in Russian], Metallurgiya, Moscow (1984).

    Google Scholar 

  23. V. S. Litvinov, E. G. Pantsyreva, and I. L. Kupriyanov, “Martensitic transformation in aluminized layer of nickel alloy,” Metalloved. Term. Obrab. Met., No. 6, 71–72 (1973).

  24. N. B. Vandysheva, G. A. Fedorov, N. V. Klyueva, et al., “Multicomponent reinforcing coatings for high-temperature parts of powerful diesels,” in: Protective Coatings on Metals [in Russian], Issue 24, Naukova Dumka, Kiev (1990), pp. 100–104.

    Google Scholar 

  25. T. Ya. Kosolapova (ed.), Properties, Fabrication, and Applications of Refractory Compounds [in Russian], Metallurgiya, Moscow (1986).

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Institute for Mechanical Engineering of the Ural Branch of the Russian Academy of Sciences, Ekaterinburg, Russia

    N. B. Pugacheva

Authors
  1. N. B. Pugacheva
    View author publications

    You can also search for this author in PubMed Google Scholar

Additional information

__________

Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 5, pp. 30–36, May, 2007.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Pugacheva, N.B. Structure and properties of alloys and coatings with ordered β-phase after heat treatment. Met Sci Heat Treat 49, 240–247 (2007). https://doi.org/10.1007/s11041-007-0043-4

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11041-007-0043-4

Keywords

Search

Navigation