Skip to main content
Log in

Application of Sound Reflection for the Confirmation of the Possibility of Calibrating Vector Receivers in Undamped Tanks

  • ACOUSTIC MEASUREMENTS
  • Published:
Measurement Techniques Aims and scope

We study the causes complicating the application of the tone-burst method for the calibration of underwater vector sound receivers. We describe an experiment performed to confirm the correctness of the procedure of calibration of a vector receiver by the method of moving complex weighted averaging when the sensitivity measured in the reverberating sound field cannot be compared with the results of other independent methods. As a criterion, we use the correctness of measurements of the parameters of distortions introduced by the sound waves reflected from the water–air interface in the direct wave of the emitter. The proposed technique makes it possible to experimentally establish the possibility of selection of the vector quantity of the direct wave from the emitter in the reverberating sound field formed in the water tank within the frequency range overlapping the range of the tone-burst method and extended to the frequencies of the chamber of standing sound waves.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.

Similar content being viewed by others

References

  1. V. A. Gordienko, V. I. Il’ichev, and L. N. Zakharov, Vector-Phase Methods in Acoustics, Nauka, Moscow (1989).

    Google Scholar 

  2. V. A. Gordienko, Vector-Phase Methods in Acoustics, Fizmatlit, Moscow (2007).

    Google Scholar 

  3. L. N. Zakharov “On methods of calibration of hydroacoustic receivers of the vibration velocity,” Akust. Zh, 17, Nо. 4, 558–562 (1971).

  4. A. E. Isaev and A. N. Matveev, “Calibration of hydrophones in a field with continuous radiation in a reverberating pool,” Akust. Zh., 55, No. 6, 727–736 (2009).

    Google Scholar 

  5. A. E. Isaev and I. V. Chernikov, “Laboratory calibration of an underwater sound receiver in the reverberation field of a noise signal,” Akust. Zh., 61, No. 6, 736–744 (2015).

    Google Scholar 

  6. I. A. Rumynskaya, Fundamentals of Hydroacoustics, Sudostroenie, Leningrad (1979).

    Google Scholar 

  7. A. E. Isaev, A. S. Nikolaenko, and А. М. Polikarpov, “Measurement of sound reflection coefficients as a function of frequency in an undamped tank,” Izmer. Tekhn., No. 4, 53–56 (2018), DOI 10.32446/0368-1025it.2018-4-53-56.

  8. The Final Report on COOMET 646/RU/14 Comparisons, https://www.coomet.net/fileadmin/user_files/DOCUMENTS/ TC_documents/TC_1.2/comparisons_reports/Final_report_646RU14.pdf, acc. 07.25.2019.

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to А. Е. Isaev.

Additional information

Translated from Izmeritel’naya Tekhnika, No. 9, pp. 53–58, September, 2019.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Isaev, А.Е., Matveev, А.N. & Nekrich, G.S. Application of Sound Reflection for the Confirmation of the Possibility of Calibrating Vector Receivers in Undamped Tanks. Meas Tech 62, 825–831 (2019). https://doi.org/10.1007/s11018-019-01701-2

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11018-019-01701-2

Keywords

Navigation