The geometric diagram of a bench for determining the instrument errors of high-precision two-dimensional optoelectronic goniometers is considered. These errors are found by measuring the angles between known spatially fixed reference directions and comparing the values obtained to the sizes of these angles measured by means of autocollimators oriented to a special caliber (calibrating prism) that fixes the point of intersection of the geometric axes of the controlled goniometer. The caliber standard is in the form of a multifaceted prism with reflective surfaces the normals to which form the required geometric diagram in space.
Similar content being viewed by others
References
A. M. Dubinovskii and E. D. Pankov, Bench Tests and Regulation of Optoelectronic Devices, Mashinostroenie, Moscow (1986).
D. A. Anikst, K. M. Konstantinovich, I. V. Mes’kin, et al., High-Precision Angle Measurements, Yu. G. Yakushenkov (ed.), Mashinostroenie, Moscow (1987).
GOST 8.009–84, GSI. Normed Metrological Characteristics of Measuring Instruments.
Yu. G. Yakushenkov, Foundations of Optoelectronic Device Design: Textbook, Logos, Moscow (2013).
V. V. Tarasov and Yu. G. Yakushenkov (ed.), Introduction to the Design of Optoelectronic Devices. A Systematic Approach: Textbook, Izd. Univ. Kniga, Moscow (2016).
V. P. Soldatov, “Scanning of the image of an object in a photoelectric motion sensor with multi-element radiation detector,” Izmer. Tekhn., No. 3, 26–28 (2015).
Yu. V. Parvulyusov and G. V. Zheboldov, “Evaluation of the principle of the design of a test bench for monitoring the precision of geodetic devices,” Priborostroenie, No. 2, 20–22 (1996).
Yu. V. Parvulyusov and M. V. Shkamanova, “Principles of modular design of metrological goniometer benches,” Geodez. Aerofotos., No. 5, 117–122 (2013).
A. S. Filonenko and N. G. Shipitsyn, Practicum on Higher Geodesy, Nedra, Moscow (1965).
Yu. V. Parvulyusov and B. V. Gonchar, “A test bench for metrological certification of high-precision goniometer devices,” Geodez. Aerofotos., No. 6, 157–162 (2000).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Izmeritel’naya Tekhnika, No. 11, pp. 19–22, November, 2017.
Rights and permissions
About this article
Cite this article
Parvulyusov, Y.B., Yakushenkov, Y.G. Principles for the Construction of a Metrological Complex for Certification of High-Precision Optoelectronic Goniometers. Meas Tech 60, 1097–1101 (2018). https://doi.org/10.1007/s11018-018-1324-6
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11018-018-1324-6