We present different practical methods of correcting for humidity in the calibration and use of critical nozzles in air at atmospheric pressure.
Similar content being viewed by others
References
GOST R 8.618-2014, GSI. State Verification Schedule for Resources Measuring the Volumetric and Mass Flow of Gas.
V. M. Krasavin, S. V. Rainchik, V. P. Ivshin, et al., “Initial reference installation of the state primary standard for units of gas volumetric and mass flow GET 118-2006. The procedure for calibration of critical nozzles.” Vestn. Kazan. Tekhn. Univ., 16, No. 10, 285–288 (2013).
ISO 9300:2005, Measurement of Gas Flow by Means of Critical Flow Venturi Nozzles.
Gas Meters. Test Rigs with Critical Nozzles, PTB, Testing Instructions, V. 25.
MI 1538-86, GSI. Critical Flow. Method for Gas Mass Flow Measurements.
ASME ANSI MFS 7M-1987, Measurement of Gas Flow by Means of Critical Flow Venturi Nozzles.
Speed of Sound in Natural Gas and Other Related Hydrocarbon Gases, AGA Report N. 10.
A. Aschenbrenner, “The influence of humidity on the flowrate of air through critical flow nozzles,” Flow Meas. Proc. FLOMECO’83 IMECO: Conf. Flow Meas., Budapest (1983).
“Revised formula for the density of moist air (CIPM-2007),” Metrologia, 45, 149–155 (2008).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Izmeritel’naya Tekhnika, No. 6, pp. 54–56, June, 2016.
Rights and permissions
About this article
Cite this article
Isaev, I.A., Gorchev, A.I. Methods of Correcting for Humidity in Determining the Metrological Characteristics of Critical Nozzles. Meas Tech 59, 633–636 (2016). https://doi.org/10.1007/s11018-016-1022-1
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11018-016-1022-1