An algorithm for calibration of two-channel conveyor-type weighers using a reference weight that simulates bulk material is presented. A calculation of the mass of a reference weight is presented.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
GOST 8.005–2002, GSI. Continuous Conveyor-Type Scales. Calibration Technique.
OIML R 50-1:1997, Continuous Totalizing Automatic Weighing Instruments (beltweighers). Part 1: Metrological and Technical Requirements. Tests.
GOST 29329–92, Weighers for Static Weighing. General Technical Requirements.
V. K. Donis, “Increasing the accuracy and efficiency of a conveyor balance,” Izmer. Tekhn., No. 9, 25–29 (1996); Measur. Techn., 39, No. 9, 928–933 (1996).
V. K. Donis, A. E. Rachkovskii, and N. Yu. Gudovskaya, “Methods of verifying continuous automatic belt weighers: state and prospects,” Izmer. Tekhn., No. 9, 28–32 (2003); Measur. Techn., 46, No. 9, 851–856 (2003).
GOST 30124–94, Weighers and Continuous Weighing Batchers. General Technical Requirements.
Ye. M. Vysochin, “Influence of elastic properties of a belt on the operation of conveyor-type weighers,” in: Vopr. Rudnich. Transp. (1958), Iss. 2, pp. 142–152.
A. V. Bocharov et al., “Tests and experience from the use of an indirect method of calibration proper and calibration measurement of conveyor-type weighers,” Glav. Metrolog, No. 6, 40–42 (2007).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Izmeritel’naya Tekhnika, No. 8, pp. 27–31, August, 2014.
Rights and permissions
About this article
Cite this article
Galin, I.A., Donis, V.K. Calibration of Continuous Conveyor-Type Weighers Using Reference Weights Without Stoppage of the Production Process. Meas Tech 57, 884–890 (2014). https://doi.org/10.1007/s11018-014-0554-5
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11018-014-0554-5