Results of measurements of roundness with the use of a coordinate measuring machine and contact reading system in scanning mode are presented. The values obtained are analyzed in the Calipso and Matlab/Octave software systems and compared.
Similar content being viewed by others
References
ASME/ANSI Y14/5 M–2009, Geometric Dimensioning and Tolerancing.
GOST R 53442–2009 (ISO 1101:2004), Basic Standards of Interchangeability. Characteristics of Geometric Articles. Tolerances of Shape, Orientation, Position, and Wobble.
O. V. Zakharov and A. V. Kochetkov, Russian Federation Patent 2240496, “A method of measuring the transverse profile of an article,” Izobret. Polezn. Modeli, No. 32 (2004).
O. V. Zakharov and B. A. Brzhozovskii, “Accuracy of centering during measurement by roundness gauges,” Izmer. Tekhn., No. 11, 20–22 (2006); Measur. Techn., 49, No. 11,1094–1097 (2006).
Ya. I. Binder et al., Russian Federation Patent 2158895, “A method of measuring the geometric shape of a nominally circular cylindrical part and a device for implementation of the method,” Izobret. Polezn. Modeli, No. 31 (2000).
B. A. Novikov, “Method for determining deviations from roundness,” Izmer. Tekhn., No. 1, 18–19 (2007); Measur. Techn., 50, No. 1, 23–25 (2007).
N. Chernov, “Circular and linear regression: Fitting circles and lines by least squares,” CRC Monographs on Stat.&Appl. (2012), No. 117.
N. I. Chernov and G. A. Ososkov, “Effective algorithms for circle fitting,” Comp. Phys. Comm., 33, 329–333 (1984).
ISO 10360-2–2006, Geometric Characteristics of Articles (GPS). Acceptance Tests and Duplicate Check Tests of Coordinate Measuring Machines. Part 2. Coordinate Measuring Machines for Determination of Dimensions.
ISO 12181–2011, Technical Requirements for the Parameters of Products (GPS). Duplicate Check Tests of Coordinate Measuring Machines. Part 4. Coordinate Measuring Machines Used in Scanning Measurement Mode.
ISO 12181–2011, Technical Requirements for the Parameters of Products (GPS). Roundness. Part 1. Dictionary and Roundness Parameters.
VDI/VDE 2617–2011, Accuracy of Coordinate Measuring Machines. Characteristics and Their Testing. Guideline for the Application of DIN EN ISO 10360 for Coordinate Measuring Machines with CT-Sensors.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Izmeritel’naya Tekhnika, No. 9, pp. 37–39, September, 2013.
Rights and permissions
About this article
Cite this article
Dovica, M., Buša, J., Palenčár, R. et al. Comparison of Methods for Analysis of Deviations from Roundness. Meas Tech 56, 1021–1025 (2013). https://doi.org/10.1007/s11018-013-0323-x
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11018-013-0323-x