Technological features of the manufacture of sets of thickness gauges for use in measuring the thickness of nickel coatings on the D16T aluminum alloy up to 100 μm with error 0.12–0.63 μm (0.4–0.6%) sufficient for inspection of thickness gauges with standard error at least 1% are presented.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
MI 1903-97, State System for Assurance of the Accuracy of Measurements, Reference Standards for the Thickness of Coatings: Inspection Methods [in Russian].
R 50.2.006-2001, State System for Assurance of the Accuracy of Measurements, State Accuracy Chart for Equipment for Measurement of the Thickness of Coatings in the Range from 1 to 20000 μm [in Russian].
L. S. Babadzhanov, M. L. Babadzhanova, Metrological Assurance of Measurements of the Thickness of Coatings [in Russian], Izd. Standartov, Moscow (2004).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Izmeritel’naya Tekhnika, No. 3, pp. 22–23, March, 2009.
Rights and permissions
About this article
Cite this article
Babadzhanov, L.S., Babadzhanova, M.L., Bezrukova, N.S. et al. A set of gauges for measuring the thickness of nickel coatings on an aluminum alloy. Meas Tech 52, 250–253 (2009). https://doi.org/10.1007/s11018-009-9259-6
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11018-009-9259-6