Abstract
The results of an investigation of the characteristics of transportable voltage standards based on stabilitrons for the purpose of using them as standards of comparison when transferring the dimension of the unit of constant voltage in accordance with the State Standard GOST 8.027-2001 are presented. It is shown that, using the standard investigated, one can transfer the dimensions of the unit of voltage with an overall relative error of 5·10−8 for a voltage of both 1.018 V and 10 V.
Similar content being viewed by others
References
State Standard GOST 8.027-2001. GSI, The State Checking System for Instruments for Measuring DC Electric Voltage and Electromotive Force}
D. Reymann et al., IEEE Trans. Instrum. Meas., 50, 206 (2001).
D. Deaver et al., IEEE Trans. Instrum. Meas., 50 ibid., p. 199.
T. J. Quinn, Metrolog., 26, 69 (1989).
V. S. Aleksandrov, A. S. Katkov, and G. P. Telitchenko, Izmer. Tekh., No.3, 6 (2002).
I. Ya. Krasnopolin, Prib. Tekh. Eksper., No.4, 200 (1993).
F. Mueller et al., Physica C, 354, 66 (2001).
T. J. Witt and D. Reymann, IEEE Proc. Sci. Meas. Technol., 147, 177 (2000).
P. Helisto and H. Seppa, IEEE Trans. Instrum. Meas., 50, 453 (2001).
T. J. Witt, IEEE Trans. Instrum. Meas., 48, 329 (1999).
L. X. Liu et al., Metrologia, 37, 213 (2000).
Additional information
__________
Translated from Izmeritel'naya Tekhnika, No. 1, pp. 34–38, January, 2006.
Rights and permissions
About this article
Cite this article
Katkov, A.S., Krasnopolin, I.Y. Investigation of the error in transferring the dimensions of the volt using a transportable stabilitron voltage standard. Meas Tech 49, 49–56 (2006). https://doi.org/10.1007/s11018-006-0061-4
Received:
Issue Date:
DOI: https://doi.org/10.1007/s11018-006-0061-4