Effect of Hot Rolling Parameters on Excess Phase Precipitation in Two-Phase Ferritic-Martensitic Steels
- 28 Downloads
Results are given for studying the effect of hot rolling parameters on morphological features of the structure and precipitation in hot rolled products destined for further cold rolling and heat treatment in a continuous annealing line. Temperatures for the end of rolling and coiling are varied with hot rolling of a laboratory melt. Depending on the combination of temperatures for the end of rolling and coiling temperature, the amount of precipitates and their preferred location vary.
Keywordstwo-phase ferritic-martensitic steel alloying microalloying effect of hot rolling temperature for the end of hot rolling coiling temperature
This work was carried out within the scope of Subsidy Agreement No. 14.625.21.0008 of 10.23.2014; unique project identifier is RFMEFI62514X0008.
- 1.H. Mohrbacher, “Strategies for producing dual phase steel using niobium microalloying,” Materials Science & Technology: Conf. and Exhib., Oct. 1, 2011, pp. 596–603.Google Scholar
- 2.E. Kh. Shakhpazov, A. I. Gordienko, A. I. Zaitsev, et al., “Increase in the level and stability of mechanical and other service properties of automobile sheet steels by controlling nonmetallic excess phase precipitation,” Metallurg, No. 9, 40–46 (2009).Google Scholar
- 4.T. Chandra, N. Wanderka, W. Reimers, and M. Ionescu, “Effect of coiling temperature on microstructure and mechanical properties of a Nb–V microalloyed steel,” Mater. Sci. Forum, 638–642, 3350–3355 (2010).Google Scholar