Abstract
An estimate is given of the magnitude of the radial forces acting on the working cone and sizing section of a draw plate in relation to the values of the main parameters in the shaping operation (the draft and friction’ the angle of the working cone’ counter-tension’ and the strain-hardening coefficient of the metal being processed).
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
S. I. Gubkin’ Plastic Deformation of Metals [in Russian]’ Metallurgizdat’ Moscow (1960)’ Vol. 3.
I. L. Perlin and M. Z. Ermanok’ Theory of Drawing [in Russian]’ Metallurgiya’ Moscow (1971).
G. N. Gur’yanov’ “Engineering methods of determining the axial stress in the drawing of circular shapes’” in: Processing of Monolithic and Layered Materials: Symposium’ MGTU’ Magnitogorsk (2005). Vol. 32’ pp. 46–57.
G. N. Gur’yanov’ “Accounting for frictional forces in the sizing section of a draw plate’” Stal’’ No. 1’ 62–64 (2007).
G. N. Gur’yanov and B. A. Kolomiets’ “Effectiveness of using draw plates with optimum working-cone angles in the cold drawing of steel wire’” in: Production of Competitive Hardware Items: Symposium (editor: A. D. Nosov)’ GOU VPO MGTU’ Magnitogorsk (2006)’ Vol. 1’ pp. 65–73.
G. N. Gur’yanov’ “Relative value of the increment of the axial stress in the sizing section of a draw plate’” Metallurg’ No. 6’ 53–55 (2007).
Author information
Authors and Affiliations
Additional information
__________
Translated from Metallurg’ No. 3’ pp. 70–72’ March’ 2008.
Rights and permissions
About this article
Cite this article
Gur’yanov, G.N. Effect of the deformation parameters on the forces in the tool during wire-drawing. Metallurgist 52, 197–201 (2008). https://doi.org/10.1007/s11015-008-9031-1
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11015-008-9031-1