The thermal stress state of the connecting unit of the shank end of the spiral coil element with a diameter of 32×4 mm with the collector with a diameter of 325×32 mm of HPH-6 and HPH-7 for the operational modes of the power unit with the WWER-1000 reactor is investigated. Its mathematical modeling is carried out, taking into account that temperature changes and stresses depend on the thermophysical and mechanical characteristics of structural materials in the operating conditions of the equipment.
Similar content being viewed by others
References
B. I. Gayvas, V. A. Dmytruk, M. M. Semerak, and T. I. Rymar, “Solving Stefan’s linear problem for drying cylindrical timber under quasi-averaged formulation,” Math. Modeling and Comp., 8, Is. 2, 150–156 (2021); DOI: https://doi.org/10.23939/mmc2021.02.150.
V. P. Kravchenko, A. N. Pavlov, and S. B. Fedorov, “Justification of the need for reconstruction of high-pressure heaters of the K-1000-6/25 turbine,” in: Abstr. of the II Conf. “Youth to the Nuclear Energy of Ukraine” [in Russian], Odessa (1995), pp. 51–55.
M. Ergashov, Z. Sh. Sadullayev, and Sh. M. Rakhmatullayeva, “Investigation of the causes of damage to the coils of high-pressure heaters,” Universum: Technical Sciences: Electron Scientific Journ., 72, No. 3 (2020); URL: https://7universum.com/ru/tech/archive/item/9044.
L. Ozhygov, A. Mitrofanov, Ye. Krainiuk, A. Bazhukov, and P. Melnyk, “Operational wear of pipelines of the second circuit of WWER-1000 power units,” Visnyk of Ternopil’ Nation. Tech.University, No. 1, 55–62 (2013).
S. P. Soloviova, Accidents and Incidents at Nuclear Power Plants: textbook [in Russian], Obninsk: INE, (1992).
V. M. Marushkin, S. S. Ivashchenko, and B. F. Vakulenko, High-Pressure Heaters for Turbines of TPP and NPP [in Russian], Energoizdat, Moscow (1985).
L. Nedelko, and W. Kastner, “Weak point analysis in response to erosion corrosion problems in nuclear power plant piping,” in: Int. Conf. ENC’ 90, (September 23–28, 1990), Lyon (1990), p. 12.
J. S. Woolsey, “Assessment and avoidance of erosion-corrosion damage in PWR feed pipework,” in: Proc. of Specialists Meeting organized by the Inter Atomic Energy Agency (September, 1988), Vienna (1990), pp. 60–66.
V. I. Baranenko, V. S. Kirov, and V. P. Kravchenko, “Erosion-corrosion wear of the metal of the inlet sections of the heater coils at NPP,” Atomic Energy, 78, Is. 2, 83–87 (1995).
T. Pyrohov, and A. Korolev, “Analysis of the thermal stress state of the flange connections elements of the emergency cooling heat exchangers during accidents of the WWER-1000 Nuclear Installation (January, 2021)”. Available at SSRN: https://ssrn.com/abstract=3766179.
S. P. Timoshenko, and N. J. Goodier, Theory of Elasticity [in Russian], Nauka, Moscow (1975).
V. V. Gerasimov, and A. S. Monakhov, Materials of Nuclear Technology [in Russian], Energoizdat, Moscow (1982).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Fizyko-Khimichna Mekhanika Materialiv, Vol. 58, No. 4, pp. 45–49, July–August, 2022
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Semerak, M.M., Rymar, T.I. & Hlova, T.Y. Mathematical Modeling of the Thermal Stress State in a Connection Unit of the Coil Shank End with High-Pressure Heater HP-2500-97 Collector. Mater Sci 58, 474–479 (2023). https://doi.org/10.1007/s11003-023-00687-1
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11003-023-00687-1