Abstract
An axisymmetric contact problem of thermoelasticity for rotating bodies is analyzed with regard for heat generation in the contact region and convective heat exchange between the bodies and the ambient medium. The distribution of stresses in the bodies is determined. Special attention is given to the maximum tangential stresses and the possibility of appearance of tensile stresses.
Similar content being viewed by others
References
J. R. Barber, “Thermoelastic contact of rotating sphere and a half-space,” Wear, 35, No. 2, 283–289 (1975).
J. R. Barber, “Some thermoelastic contact problems involving frictional heating,” Q. J. Mech. Appl. Math., 29, 1–13 (1976).
M. B. Generalov, B. A. Kudryavtsev, and V. Z. Parton, “Contact problem of thermoelasticity for rotating bodies,” Izv. Akad. Nauk SSSR, Mekh. Tverd. Tela, No. 3, 46–52 (1976).
D. V. Grylitsky and V. I. Pauk, “Some quasistationary contact problems for half-space involving heat generation and radiation,” Int. J. Eng. Sci., 33, No. 12, 1773–1781 (1995).
D. V. Grylitsky and V. I. Pauk, “The plane contact problem of steady thermoelasticity taking heat generation into account,” J. Appl. Math. Mech., 61, No. 6, 1007–1012 (1997).
V. P. Levytskyi and V. M. Onyshkevych, “Plane contact problem with heat generation account of friction,” Int. J. Eng. Sci., 34, No. 1, 101–112 (1996).
D. V. Grilitskii and R. D. Kul’chyts’kyi-Zhyhailo, “Axisymmetric contact problem of thermoelasticity for rotating bodies,” Fiz.-Khim. Mekh. Mater., 27, No. 3, 93–97 (1991).
A. A. Yevtushenko and R. D. Kulchytsky-Zhyhailo, “Determination of limiting radii of the contact area in axisymmetric contact problems with frictional heat generation,” J. Mech. Phys. Solids, 43, No. 4, 599–604 (1995).
A. A. Yevtushenko and R. D. Kulchytsky-Zhyhailo, “Two axisymmetrical contact problems with the steady-state frictional heating,” J. Theor. Appl. Mech., 34, No. 4, 767–779 (1996).
A. A. Yevtushenko and R. D. Kulchytsky-Zhyhailo, “Effect of the convective cooling on the solution of the thermoelastic contact problems with the friction heat generation,” J. Theor. Appl. Mech., 35, No. 1, 125–135 (1997).
R. Kul’chyts’kyi-Zhyhailo and O. Evtushenko, “Convective cooling in contact problems of thermoelasticity with frictional heat generation,” Fiz.-Khim. Mekh. Mater., 33, No. 6, 75–80 (1997).
R. Kul’chyts’kyi-Zhyhailo, “Distribution of stresses in axisymmetric contact problems with regard for heat generation,” Tren. Iznos, 21, No. 3, 238–245 (2000).
R. Kulchytsky-Zhyhailo, “A simplified solution for three-dimensional contact problem with heat generation,” Int. J. Eng. Sci., 39, No. 3, 303–315 (2001).
A. Seweryn and Z. Mróz, “On the criterion of damage evolution for variable multiaxial stress state,” Int. J. Solids Struct., 35, 1599–1616 (1997).
Z. Mróz and A. Seweryn, “Nonlocal failure and damage evolution rule: application to a dilatant crack model,” J. Phys. IV France, 8, 257–268 (1998).
S. Timoshenko and J. N. Goodier, Theory of Elasticity, McGraw-Hill, New York (1951).
R. Kul’chyts’kyi-Zhyhailo, “Axisymmetric contact problem for inhomogeneous rotating bodies with regard for heat generation,” Tren. Iznos, 22, No. 2, 140–149 (2001).
J. Dundurs and C. Panek, “Heat conduction between bodies with wavy surfaces,” Int. J. Heat Mass Transfer, 19, 731–736 (1976).
Author information
Authors and Affiliations
Additional information
__________
Translated from Fizyko-Khimichna Mekhanika Materialiv, Vol. 41, No. 6, pp. 26–32, November–December, 2005.
Rights and permissions
About this article
Cite this article
Kul’chyts’kyi-Zhyhailo, R. Contact stresses in rotating bodies with regard for heat generation and convective heat exchange. Mater Sci 41, 734–742 (2005). https://doi.org/10.1007/s11003-006-0038-0
Received:
Issue Date:
DOI: https://doi.org/10.1007/s11003-006-0038-0