Abstract
This paper describes the preparation of samples for an experiment to measure the cross-section for 235U(n,n′)235mU in a fast fission spectrum of neutrons provided by a fast pulsed reactor/critical assembly. Samples of 235mU have been prepared for the calibration of the internal conversion electron detector that is used for the 235mU measurement. Two methods are described for the preparation of 235mU. The first method used a U-Pu chemical separation based on anion-exchange chromatography and the second method used an alpha recoil collection method. Thin, uniform samples of 235mU+235U were prepared for the experiment using electrodeposition.
Similar content being viewed by others
References
J. E. Lynn, A. C. Hayes, Phys. Rev., C67 (2003) 014607.
V. Méot, G. Belier, Private communication.
E. Sauvan, V. Méot, J. C. Baudin, CEA/DIF/DPTA/02/98/DO, 1998.
R. P. Larsen, R. D. Oldham, Talanta, 22 (1975) 577.
W. L. Talbert Jr., J. W. Starner, R. J. Estep, S. J. Balestrini, M. Attrep Jr., D. W. Efurd, F. R. Roensch, Phys. Rev., C36 (1987) 1896.
J. Kleinberg (Ed.), Collected Radiochemical and Geochemical Procedures, 5th ed., 1990, p. I–176.
A. Talvitie, Anal. Chem., 44 (1972) 280.
G. Müllen, D. C. Aumann, Nucl. Instr. Meth., 128 (1975) 425.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Bond, E.M., Glover, S., Vieira, D.J. et al. Preparation of 235mU targets for 235U(n,n′)235mU cross section measurements. J Radioanal Nucl Chem 276, 549–554 (2008). https://doi.org/10.1007/s10967-008-0540-y
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10967-008-0540-y