Abstract
It is evident that the microstructure and superconducting properties of YBa2Cu3O7−σ (YBCO) thick films are highly dependent upon the route of the precursor. The precursor which was used in the preparation of YBCO thick films was produced using sol gel route technique. The screen printing technique was used in the fabrication of YBCO superconducting thick films on yttria stabilized zirconia (YSZ) substrates. The effect of slow cooling rate and slow cooling window on texturing, microstructure and superconducting properties of the melt processed films was carried out. Optimizing the melt processing program was effective in increasing the molten viscosity, keeping the liquid and hence relatively large grain size that has been obtained. Moreover, grain morphologies like which was found in YBCO bulk materials was observed.
Similar content being viewed by others
References
Langhorn, J., McGinn, P.J.: Physica C 312, 169 (1999)
Moussa, M.A., Abell, J.S., Shields, T.C.: Supercond. Sci. Technol. 15, 1467 (2002)
Langhorn, J.B., McGinn, P.J.: Physica C 323, 79 (1999)
Moussa, M.A.: Fabrication and characterization of Nd123 high-temperature superconducting thick films on yttria stabilized zirconia substrates. Ph.D. Thesis, Birmingham University, UK (2003)
Moussa, M.A., Abell, J.S., Shields, T.C.: J. Mater. Sci. 42, 692 (2007)
Wu, M.K., Ashburn, J.R., Torng, C.J., Hor, P.H., Meng, R.L., Gao, L., Huang, Z.L., Wang, Y.Q., Chu, C.W.: Phys. Rev. Lett. 58, 908 (1987)
Varadaraju, U.V., Subba Rao, G.V.: In: Narlikar, A. (ed.) Studies of High Temperature Superconductors, p. 229. Nova Science, New York (1989)
Barboux, P., Campion, I., Daglish, S., Livage, J., Genicon, J.L., Sulpice, A., Tournier, R.: J. Non-Cryst. Sol. 720, 147 (1992)
Kumar, P., Pillai, V., Shah, D.O.: J. Mater. Sci. Lett. 12(3), 162 (1993)
Aoki, A., Ohno, S., Muramatsu, Y.: J. Non-Cryst. Sol. 704, 147 (1992)
Nishio, T., Fujiki, Y.: J. Mater. Sci. Lett. 12(6), 394 (1993)
Pak, S.S., Montgomery, F.C., Duggan, D.M., Chen, K.C., Mazdiyasni, K.S., Tasi, P.K., Paulius, M., Maple, M.B.: J. Am. Ceram. Soc. 75(8), 2268 (1992)
Coppa, N.V., Myer, G.H., Salomon, R.E., Bura, A., O’Reilly, J.W., Crow, J.E., Davies, P.K.: J. Mater. Res. 7(8), 2017 (1992)
Calleja, A., Segarra, M., Serradilla, I.G., Capdevila, X.G., Fernandez, A.I., Espiell, F.: J. Eur. Ceram. Soc. 23, 1369 (2003)
Moussa, M.A., Abell, J.S., Shields, T.C.: J. Mater. Sci. 40, 4859 (2005)
Moussa, M.A.: Cryogenics 49, 17 (2009)
Thomas, P.S., Guerbois, J.-P., Russell, G.F., Briscoe, B.J.: J. Therm. Anal. Cal. 64, 501 (2001)
Moussa, M.A., Shields, T.C., Abell, J.S.: Physica C 181, 372–376 (2002)
Button, T.W., Alford, N.M., Wellhöfer, F., Shields, T.C., Abell, J.S., Day, M.: IEEE Trans. Mag. 27, 1434 (1991)
Murakami, M., Sakai, N., Higuchi, T., Yoo, S.I.: Supercond. Sci. Technol. 9, 1015 (1996)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Moussa, M.A.A., El-Hefnawy, S.M., Abou-Alkheer, M.M. et al. Melt Processing of YBCO Thick Films Fabricated by Sol Gel Route Powder on YSZ. J Supercond Nov Magn 22, 479–485 (2009). https://doi.org/10.1007/s10948-009-0444-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10948-009-0444-2