Abstract
The bending modulus of elasticity has been used as a wood quality predictor due to the good correlation between bending stiffness and strength. In recent years, there has been an increasing use of nondestructive testing techniques based on dynamic tests to assess wood quality. The objective of this study is to evaluate the results obtained with the application of transverse vibration test to measure the bending modulus of elasticity of Corymbia citriodora logs. The approach used estimated the log cylinders with the diameter equal to the diameter measured at half-length. A sample of 38 C. citriodora logs was tested in free transverse vibration and static bending tests, their diameter measured at half-length ranged from 13.6 to 20 cm and the length ranged between 4 and 4.4 m. A strong correlation (\(\hbox {R}^{2} = 0.92\)) was found between static and dynamic bending modulus of elasticity. The transverse vibration test was faster than the static bending test. The results indicate that the free transverse vibration test provides accurate measurements of bending modulus of elasticity of C. citriodora logs.
This is a preview of subscription content, access via your institution.









References
Hellier, C.: Handbook of Nondestructive Evaluation. McGraw-Hill, New York (2003)
Wolfe, R., Hernandez, H.: Trussed assemblies form small-diameter round timbers, In: Pacific Timber Engineering Conference, New Zealand (1999)
ASTM D 1036: Standard Test Methods of Static Tests of Wood Poles. ASTM International. West Conshohocken. PA (2012)
Gonçalves, R., Graziano, M.P.S., Herrera, S., Bartholomeu, A.: Using ultrasonic wave propagation to grading new wooden and concrete poles. E. J. Nondestruct. Test. Ultrason. 12, 1–5 (2007)
Stambaugh, M., Mcmurry, E. R., Maschall, J.M., Guyette, R.: Use and calibration of the Resistograph for analysis of oak (Quercus sp.) decay and callus formation associated with fire scars, Research report. University of Missouri. Department of Forestry. Columbia, Missouri. USA (2008)
Carreira, M.R., Molina, J.C., Calil Júnior, C., Dias, A.A.: Previsão do módulo de ruptura a flexão em toras de Eucalyptus sp pelo ensaio de vibração transversal. In: 8th Congresso Nacional de Mecânica Experimental (2010)
Rais, A., Pretzsch, H., Van de Kuilen, J.-W.G.: Roundwood pre-grading with longitudinal acoustic waves for production of structural boards. Eur. J. Wood Prod. 72, 87–98 (2014)
Deflorio, G., Siegfried, F., Schwarzwe, F.W.M.R.: Detection of incipient decay in tree stems with sonic tomography after wounding and fungal inoculation. Wood Sci. Technol. 42, 117–132 (2008). doi:10.1007/s00226-007-0159-0
Carreira, M.R., Segundinho, P.G.A., Dias, A.A.: Determination of the E/G ratio of wood logs using transverse vibration. Wood Res. 57(2), 207–220 (2012)
Wang, X., Ross, R.J., Mattson, J.A., Erickson, J.R., Forsman, J.W., Geske, E.A.: Nondestructive evaluation techniques for assessing modulus of elasticity and stiffness of small-diameter logs. For. Prod. J. 52(2), 79–85 (2002)
Green, D.W., Gorman, T.M., Evans, J.W., Murphy, J.F.: Mechanical grading of round timber beams. J. Mater. Civil Eng. 18(1), 1–10 (2006)
Rao, S.S.: Mechanical Vibrations, 5th edn. Prentice Hall, Upper Saddle River (2011)
Zangiácomo, A.L.: Estudo de elementos roliços de madeira. Doctoral thesis. Escola de Engenharia de São Carlos, Universidade de São Paulo. São Carlos, São Paulo. Brazil (2007)
Cho, C.L.: Comparison of three methods for determining Young’s modulus of wood. Taiwan J. For. Sci. 22(3), 297–306 (2007)
Allemang, R.J., Brown, D.L.: Experimental Modal Analysis. In: Harris’ Shock and Vibration Handbook, 5th edn. New York: McGraw-Hill (2009). ISBN 0-07-137081-1
McConnell, K.G., Varoto, P.S.: Vibration Testing—Theory and Practice, 2nd edn. Wiley, Hoboken (2008)
Levy, E.C.: Complex-curve fitting. IRE Trans. Autom. Control 4(1), 37–43 (1959)
Astm, D. 198: Standard Test Methods of Static Tests of Lumber in Structural Sizes. ASTM International. West Conshohocken, PA (2008)
Kottegoda, N.T., Rosso, R.: Applied Statistics for Civil and Environmental Engineers. Wiley-Blackwell, London (2008)
Wang, X., Ross, R.J., Mattson, J.A., Erickson, J.R., Forsman, J.W., Geske, E.A., Wehr, M.A.: Several nondestructive evaluation techniques for assessing modulus of elasticity and stiffness of small-diameter logs. For. Prod. J. 52(2), 79–85 (2002)
Chui, Y.H., Barclay, D.W., Cooper, P.A.: Evaluation of wood poles using a free vibration technique. J. Test. Eval. 27(3), 191–195 (1999)
Acknowledgements
We are grateful to CNPq (National Council for Scientific and Technological Development - Brazil) and CAPES (Coordination for the Improvement of Higher Education Personnel - Brazil) for the scholarship and financial support given to this research.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Carreira, M.R., Dias, A.A. & de Alcântara Segundinho, P.G. Nondestructive Evaluation of Corymbia citriodora Logs by Means of the Free Transverse Vibration Test. J Nondestruct Eval 36, 26 (2017). https://doi.org/10.1007/s10921-017-0401-0
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s10921-017-0401-0