Abstract
Most companies in the marble sector are planning and programming their production using portfolio of orders, their experiences, and practical forecasts. Renta? Marble plant is chosen to carry out this study, where all production steps have been observed and recorded for a year. The authors used production capacity and loss reports, as well as software Lingo 8.0 in their researches. The scope of application for the linear programming method is defined. Software Lingo 8.0 is run for the best, worst, and average production conditions with respective assumptions made. The efficiency of products produced at the plant to obtain the highest revenue with a reasonable rate of loss is evaluated. The marketing policies for companies are developed.
Similar content being viewed by others
References
D. Aslan, Production Planning (4th Edition), Dokuz Eylul Univ., Faculty of Engineering Publication Unit, Izmir (2002).
H. Bakoğlu, Linear Programming, Dokuz Eylul Univ., Faculty of Engineering Publication Unit, Izmir (1982).
C. Ogut and I. Orientation, Lecture Notes, Dokuz Eylul Univ., Faculty of Engineering Publication Unit, Izmir (1980).
A. Sari, Use of Linear Programming Technique in Production Planning. Dokuz Eylul Univ., Fac. of Eng., Industrial Eng. Dept., Diploma Thesis (2001).
A. Sultan, Linear Programming, CA-San Diego: Academic Press (1993).
H. A. Taha, Orientation Research (6th Edition), Literatür Publishing, İstanbul (2000).
S. Yikilmaz, Production Planning by Means of Linear Programming, Dokuz Eylul Univ., Fac. of Eng., Industrial Eng. Dept., Diploma Thesis (2002).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Fiziko-Tekhnicheskie Problemy Razrabotki Poleznykh Iskopaemykh, No. 1, pp. 69–77, January–February, 2010.
Rights and permissions
About this article
Cite this article
Ozsan, O., Simsir, F. & Pamukcu, C. Application of linear programming in production planning at marble processing plants. J Min Sci 46, 57–65 (2010). https://doi.org/10.1007/s10913-010-0008-7
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10913-010-0008-7