Abstract
We present preliminary results on characterisation of voltage biased superconducting bolometers with an NbSi alloy sensor. I(V) curves as well as complex impedance and noise measurements are carried out in a dilution fridge with a pulse tube as a first stage cooler. SQUIDs polarization and addressing are controlled by a cold ASIC in which a SiGe amplifier has been implemented. First characterisations were done on full membrane bolometers and show a noise level of about \(10^{-16}\ \mathrm{W}/\sqrt{\mathrm{Hz}}\). Those detectors are developed for the QUBIC experiment, a B-modes telescope that will be deployed in Antactica in 2013.
Similar content being viewed by others
References
Richards, P. et al., in Submillimetre and Far-Infrared Space Instrumentation, ESA SP-388, p. 123 (1996)
Ullom, J.N. et al., Appl. Phys. Lett. 84, 4206 (2004)
Crauste, O. et al., J. Low Temp. Phys. 163, 60 (2011)
Piat, M. et al., in SPIE Conf. Series, vol. 7020 (2008)
Prêle, D. et al., in AIP Conf. Series, vol. 1185, 534 (2009)
Prêle, D. et al., in P. Kern (ed.), ESA SP-37, p. 141 (2009)
Lindeman, M.A. et al., Rev. Sci. Instrum. 75, 1283 (2004)
Acknowledgements
This work is supported by CNES, CNRS, Paris Diderot and Paris-Sud universities under the BSD French R & D project (B-mode Superconducting Detectors).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Martino, J., Prele, D., Piat, M. et al. Characterization of NbSi TES Bolometers: Preliminary Results. J Low Temp Phys 167, 176–181 (2012). https://doi.org/10.1007/s10909-012-0515-9
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10909-012-0515-9