Skip to main content
SpringerLink
Log in

Modeling an Elastic Stress in a Colloid Capillary-Porous Body in Its Dehydration by Depressurization

  • Published:
Journal of Engineering Physics and Thermophysics Aims and scope

Consideration has been given to combined effects of the pressure gradient and shrinkage on the distribution of mechanical stresses in a wood specimen subjected to dehydration by depressurization. The time variation in the moisture distribution across the specimen cross section has been identified. The observed redistribution of moisture from the center to the specimen surface results in the pressure gradient values being relatively low. Due to a more uniform water content, there is also a decrease in mechanical stresses associated with shrinkage. Calculations have shown that the effects of shrinkage are the most substantial in the case of water content reduction below the wood hygroscopicity limit (fiber saturation point), and also, in the case of dehydration of large-size specimens. The obtained dependences can be used for identifying treatment regimes for various materials without deterioration in their consumer properties.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. Yu. A. Mikhailov, Drying by Superheated Steam [in Russian], Énergiya, Moscow (1967).

  2. R. G. Safin, V. A. Lashkov, L. G. Golubev, and R. R. Safin, Mathematical model of vacuum-oscillating drying of lumber, J. Eng. Phys. Thermophys., 75, No. 2, 384–389 (2002).

    Article  Google Scholar 

  3. V. P. Kozhin and N. M. Gorbachev, Application of the depressurization method in high-temperature oscillating drying of large-size lumber products, J. Eng. Phys. Thermophys., 84, No. 2, 233–240 (2011).

    Article  Google Scholar 

  4. M. A. Brich, N. M. Gorbachev, I. A. Koznacheev, D. S. Makarenko, Yu. G. Grozberg, and A. L. Adamovich, Conditions for the destruction of a wet colloid capillary porous material in thermomechanical depressurization treatment, Vestn. Polotsk. Gos. Univ., Ser. B, Promyshlennost′, Prikl. Nauki, No. 3, 45–49 (2020).

  5. D. F. Ziatdinova, R. G. Safin, and R. R. Ziatdinov, Mathematical description of the process of separation of fibers of high-moisture wood particles by depressurization, Vestn. Kazansk. Gos. Tekh. Univ., Issue 7, 62–68 (2011).

  6. A. Yu. Ishlinskii, Applied Problems of Mechanics [in Russian], Nauka, Moscow (1986).

  7. G. Torgovnikov and P. Vinden, Microwave wood modification technology and its applications, Forest Prod. J., 60, No. 2, 173–182 (2010).

    Article  Google Scholar 

  8. M. A. Brich, N. M. Gorbachev, and I. A. Koznacheev, Modeling processes occurring in thermomechanical treatment of timber-based materials by the depressurization method, Heat and Mass Transfer–2016, A. V. Luikov Heat and Mass Transfer Institute, National Academy of Sciences of Belarus, Minsk (2017), pp. 61–64.

  9. M. Britch, N. Gorbachov, I. Koznacheev, and D. Makarenko, Elastic tensions in a wood material subjected to thermomechanical treatment by pressure drop, Therm. Sci. Eng. Prog., 16, Article ID 100457 (2020).

  10. M. Muskat, The Flow of Homogeneous Fluids Through Porous Media, I. W. Edwards, Inc., Ann Arbor, Michigan (1946).

  11. S. Patankar, Numerical Methods of Solving Problems of Heat Transfer and Fluid Dynamics [in Russian], Énergoatomizdat, Moscow (1984).

  12. L. D. Landau and E. M. Lifshits, Theory of Elasticity [in Russian], Nauka, Moscow (1987).

  13. W. T. Simpson, Drying and control of moisture content and dimensional changes, in: Wood Handbook — Wood as an Engineering Material, U.S. Department of Agriculture Forest Service, Madison (1999).

    Google Scholar 

  14. P. S. Sergovskii and A. I. Rasev, Hydrothermal Treatment and Preservation of Wood [in Russian], Lesnaya Promyshlennost’, Moscow (1987).

  15. D. W. Green, J. E. Winandy, and D. E. Kretschmann, Mechanical properties of wood, in: Wood Handbook — Wood as an Engineering Material, U. S. Department of Agriculture Forest Service, Madison (1999).

  16. L. M. Perelygin and B. N. Ugolev, Wood Science [in Russian], Lesnaya Promyshlennost’, Moscow (1971).

Download references

Author information

Authors and Affiliations

  1. A. V. Luikov Heat and Mass Transfer Institute, National Academy of Sciences of Belarus, 15 P. Brovka Str, 220072, Minsk, Belarus

    N. M. Gorbachev, M. A. Brich & I. A. Koznacheev

Authors
  1. N. M. Gorbachev
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. M. A. Brich
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. I. A. Koznacheev
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to I. A. Koznacheev.

Additional information

Translated from Inzhenerno-Fizicheskii Zhurnal, Vol. 95, No. 3, pp. 729–733, May–June, 2022.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Gorbachev, N.M., Brich, M.A. & Koznacheev, I.A. Modeling an Elastic Stress in a Colloid Capillary-Porous Body in Its Dehydration by Depressurization. J Eng Phys Thermophy 95, 716–720 (2022). https://doi.org/10.1007/s10891-022-02528-5

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10891-022-02528-5

Keywords

Search

Navigation