Skip to main content

Advertisement

SpringerLink
Log in

High stable with efficient dye-sensitized solar cell-based Al2O3/graphene hybrid photoanode fabricated by simple household microwave irradiation technique

  • Published:
Journal of Materials Science: Materials in Electronics Aims and scope Submit manuscript

Abstract

A facile and one-step microwave irradiation approach was adapted to fabricate the hybrid photoanode of aluminum oxide (Al2O3)/graphene (GR) nanocomposite and scientifically investigated their structural, morphological and optical properties by XRD, TEM, Raman, UV, PL and BET analysis. XRD and TEM results exposed that crystal symmetry and exhibited face centered lattice with uniform plate-like nanoparticles are homogeneously covered on the surface of the graphene sheets. Mesoporous with nature with high pore size and huge surface area of Al2O3/GR is identified by N2 adsorption–desorption analysis. A significant reduction in the band gap energy (4.42–3.62 eV) and rapid electron–hole pair generation process of the hybrid materials was found by UV-DRS and PL spectra analysis. Sandwich type solar cell was fabricated by deposition the hybrid materials on FTO glass substrate and technically studied the photovoltaic (PV) parameters through J–V characteristics. The results express that Al2O3/GR hybrid photoanode show fabulous photo conversion efficiency (PCE) of (8.21%) and high stability than compared with bare Al2O3.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9

Similar content being viewed by others

References

  1. J. Qi, K. Zhao, G. Li, Y. Gao, H. Zhao, R. Yu, Z. Tang, Multi-shelled CeO2 hollow microspheres as superior photocatalysts for water oxidation. Nanoscale 6, 4072–4077 (2014)

    Article  CAS  Google Scholar 

  2. Q. Zhang, E. Uchaker, S.L. Candelaria, G. Cao, Nanomaterials for energy conversion and storage. Chem. Soc. Rev. 42, 3127–3171 (2013)

    Article  CAS  Google Scholar 

  3. N.Q. Wu, J. Wang, D. Tafen, H. Wang, J.-G. Zheng, J.P. Lewis, X. Liu, S.S. Leonard, A. Manivannan, Shape-enhanced photocatalytic activity of single-crystalline anatase TiO2 (101) nanobelts. J. Am. Chem. Soc. 132, 6679–6685 (2010)

    Article  CAS  Google Scholar 

  4. J. Tian, Y. Sang, G. Yu, H. Jiang, X. Mu, H. Liu, A Bi2WO6-based hybrid photocatalyst with broad spectrum photocatalytic properties under UV, visible, and near-infrared irradiation. Adv. Mater. 25, 5075–5080 (2013)

    Article  CAS  Google Scholar 

  5. J.-L. Lan, Z. Liang, Y.-H. Yang, F.S. Ohuchi, S.A. Jenekhe, G. Cao, The effect of SrTiO3: ZnO as cathodic buffer layer for inverted polymer solar cells. NanoEnergy 4, 140–149 (2014)

    CAS  Google Scholar 

  6. L. Wang, T. Sasaki, Titanium oxide nanosheets: graphene analogues with versatile functionalities. Chem. Rev. 114, 9455–9486 (2014)

    Article  CAS  Google Scholar 

  7. W. Zhou, J.J. Coleman, Semiconductor quantum dots. Curr. Opin. Solid State Mater. Sci. 20, 352–360 (2016)

    Article  CAS  Google Scholar 

  8. M. Kouhnavard, S. Ikeda, N.A. Ludin, N.B. Ahmad Khairudin, B.V. Ghaffari, M.A. Mat-Teridi, M.A. Ibrahim, S. Sepeai, K. Sopian, A review of semiconductor materials as sensitizers for quantum dot-sensitized solar cells. Renew. Sustain. Energy Rev. 37, 397–407 (2014)

    Article  CAS  Google Scholar 

  9. J. Tian, G. Cao, Design, fabrication and modification of metal oxide semiconductor for improving conversion efficiency of excitonic solar cells. Coord. Chem. Rev. 320–321, 193–215 (2016)

    Article  Google Scholar 

  10. Q. Luo, Y. Gu, J. Li, N. Wang, H. Lin, Efficient ternary cobalt spinel counter electrodes for quantum-dot sensitized solar cells. J. Power Sources 312, 93–100 (2016)

    Article  CAS  Google Scholar 

  11. S. Bak, D. Kim, H. Lee, Graphene quantum dots and their possible energy applications: a review. Curr. Appl. Phys. 16(9), 1192–1201 (2016)

    Article  Google Scholar 

  12. J. Qi, L. Wang, C. Biswas, G. Zhang, L. Sun, Z. Wang, X. Hu, Y. Zhang, Enhanced power conversion efficiency of CdS quantum dot sensitized solar cells with ZnO nanowire arrays as the photoanodes. Opt. Commun. 349, 198–202 (2015)

    Article  CAS  Google Scholar 

  13. L. Zhang, W. Wu, S. Zhang, L. Que, J. Wu, Preparation of high efficiency CdS quantum-dot-sensitized solar cells based on ordered TiO2 nanotube arrays. Ceram. Int. 42, 8058–8065 (2016)

    Article  Google Scholar 

  14. C.K. Kamaja, R.R. Devarapalli, Y. Dave, J. Debgupta, M.V. Shelke, Synthesis of novel Cu2S nanohusks as high performance counter electrode for CdS/CdSe sensitized solar cell. J. Power Sources 315, 277–283 (2016)

    Article  CAS  Google Scholar 

  15. J. Tan, Y. Shen, Z. Zhang, Q. Wu, F. Gu, M. Cao, L. Wang, Highly-efficient quantum dot-sensitized solar cells based on Sn doped ZnO and CuS electrodes. J. Mater. Sci. Mater. Electron. 26, 2145–2150 (2015)

    Article  CAS  Google Scholar 

  16. J.B. Zhang, F.Y. Zhao, G.S. Tang, L. Yuan, Influence of highly efficient PbS counter electrode on photovoltaic performance of CdSe quantum dots sensitized solar cells. J. Solid State Electrochem. 17, 2909–2915 (2013)

    Article  CAS  Google Scholar 

  17. P. Auerkari, Mechanical and Physical Properties of Engineering Alumina Ceramics (VTT Technical Research Center of Finland, Finland, 1996)

    Google Scholar 

  18. R. Banerjee, I. Manna, Ceramic Nanocomposites (Woodhead Publishing, Philadelphia, 2013)

    Book  Google Scholar 

  19. L. Zhang, Z. Wang, J. Wu, G. Shi, H. Xu, Comparison of the homemade and commercial graphene in heightening mechanical properties of Al2O3 ceramic. Ceram. Int. 43, 2143–2149 (2017)

    Article  CAS  Google Scholar 

  20. H. Si, Q. Liao, Z. Zhang, Y. Li, X. Yang, G. Zhang, Z. Kang, Y. Zhang, An innovative design of perovskite solar cells with Al2O3 inserting at ZnO/perovskite interface for improving the performance and stability. Nano Energy 22, 223–231 (2016)

    Article  CAS  Google Scholar 

  21. J. Song, F. Huang, J. Chen, S. Liu, K. Cao, M. Wang, High open-circuit voltage perovskite solar cell based on CH3NH3PbBr3 light absorber using hole-conductor-layer-free structure. Chem. Eng. Trans. 62, 1147–1152 (2017)

    Google Scholar 

  22. P.R. Pudasaini, A.A. Ayon, Low-cost, high-efficiency organic/inorganic hetero-junction hybrid solar cells for next generation photovoltaic device. J. Phys: Conf. Ser. 476, 012140 (2013)

    Google Scholar 

  23. P. Pokharel, D.S. Lee, Thermal and mechanical properties of reduced graphene oxide/polyurethane nanocomposite. J. Nanosci. Nanotechnol. 14, 5718–5721 (2014)

    Article  CAS  Google Scholar 

  24. D.C. Marcano, D.V. Kosynkin, J.M. Berlin, A. Sinitskii, Z. Sun, A. Slesarev et al., Improved synthesis of graphene oxide. ACS Nano 4, 4806–4814 (2010)

    Article  CAS  Google Scholar 

  25. M. Parthibavarman, K. Vallalperuman, S. Sathishkumar, M. Durairaj, K. Thavamani, A novel microwave synthesis of nanocrystalline SnO2 and its structural optical and dielectric properties. J. Mater. Sci. Mater. Electron. 25, 730–735 (2014)

    Article  CAS  Google Scholar 

  26. M.S. Dresselhaus, A. Jorio, M. Hofmann, G. Dresselhaus, R. Saito, Perspectives on carbon nanotubes and graphene Raman spectroscopy. Nano Lett. 10, 751–758 (2010)

    Article  CAS  Google Scholar 

  27. A.C. Ferrari, Raman spectroscopy of graphene and graphite: disorder, electron–phonon coupling, doping and nonadiabatic effects. Solid State Commun. 143, 47–57 (2007)

    Article  CAS  Google Scholar 

  28. M. Parthibavarman, S. Sathishkumar, M. Jayashree, R. BoopathiRaja, Microwave assisted synthesis of pure and Ag doped SnO2 quantum dots as novel platform for high photocatalytic activity performance. J. Cluster Sci. 30, 351–363 (2019)

    Article  CAS  Google Scholar 

  29. M. Parthibavarman, S. Sathishkumar, S. Prabhakaran, M. Jayashree, R. BoopathiRaja, High visible light-driven photocatalytic activity of large surface area Cu doped SnO2 nanorods synthesized by novel one-step microwave irradiation method. J. Iran. Chem. Soc. 15, 2789–2801 (2018)

    Article  CAS  Google Scholar 

  30. J.W. Elam, D. Routkevitch, S. George, Properties of ZnO/Al2O3 alloy films grown using atomic layer deposition techniques. J. Electrochem. Soc. 150, G339–G347 (2003)

    Article  CAS  Google Scholar 

  31. R. BoopathiRaja, M. Parthibavarman, A. Nishara Begum, Hydrothermal induced novel CuCo2O4 electrode for high performance supercapacitor applications. Vacuum 165, 96–104 (2019)

    Article  CAS  Google Scholar 

  32. R. BoopathiRaja, M. Parthibavarman, Hetero-structure arrays of MnCo2O4 nanoflakes@ nanowires grown on Ni foam: design, fabrication and applications in electrochemical energy storage. J. Alloys Compd. 811, 152084 (2019)

    Article  CAS  Google Scholar 

  33. Z. Li, F. Gong, G. Zhou, Z.-S. Wang, NiS2/reduced graphene oxide nanocomposites for efficient dye-sensitized solar cells. J. Phys. Chem. C 117, 6561–6566 (2013)

    Article  CAS  Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Department of Chemistry, Paavai Engineering College, Namakkal, Tamilnadu, 637018, India

    R. Gayathri & G. Raja

  2. Department of Chemistry, Vivekanandha College of Arts and Science for Women, Tiruchengode, Tamilnadu, 637205, India

    P. Rajeswaran

Authors
  1. R. Gayathri
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. G. Raja
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. P. Rajeswaran
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to R. Gayathri.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Gayathri, R., Raja, G. & Rajeswaran, P. High stable with efficient dye-sensitized solar cell-based Al2O3/graphene hybrid photoanode fabricated by simple household microwave irradiation technique. J Mater Sci: Mater Electron 31, 9742–9752 (2020). https://doi.org/10.1007/s10854-020-03520-6

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10854-020-03520-6

Search

Navigation