Skip to main content
Log in

A new polyacrylonitrile fiber for direct carbonization without oxidation

  • Composites
  • Published:
Journal of Materials Science Aims and scope Submit manuscript

Abstract

Polyacrylonitrile (PAN) was cyclized by heating in an inert atmosphere and then dissolved in sulfuric acid and oxidized by nitric acid, resulting in product named OCPAN. The OCPAN was dissolved along with PAN and spun into fibers, getting modified PAN fiber (MPAN), to realize self-crosslinking and direct carbonization. The chemical structure of the OCPAN and its compatibility and co-carbonization effects with PAN were characterized through characterization methods of optical microscopy, Fourier transform infrared spectroscopy and thermogravimetric analysis. The structure and properties of the resultant carbon fibers were investigated by scanning electron microscope and monofilament strength tester. The results show that ketone aromatic heterocycles are produced in OCPAN, which are able to promote the formation of a stable structure of carbon network and produce crosslinking with PAN molecules. The carbon yield of the MPAN fiber after direct carbonation under 900 °C temperature in nitrogen is 23% higher than that of the PAN fiber without oxidation carbonized under the same condition, while the strength of the final carbon fiber is a bit lower than that derived from the PAN fiber through pre-oxidation. Therefore, the direct carbonation of PAN fiber is basically realized.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10

Similar content being viewed by others

References

  1. Ma Q, Gao A, Tong Y, Zhang Z (2016) The densification mechanism of polyacrylonitrile carbon fibers during carbonization. New Carbon Mater 31:550–554

    Article  Google Scholar 

  2. Zhang Y, Tajaddod N, Song K, Minus ML (2015) Low temperature graphitization of interphase polyacrylonitrile (PAN). Carbon 91:479–493

    Article  Google Scholar 

  3. Tong Y, Wang X, Su H, Xu L (2011) Oxidation kinetics of polyacrylonitrile-based carbon fibers in air and the effect on their tensile properties. Corros Sci 53:2484–2488

    Article  Google Scholar 

  4. Rahaman MSA, Ismail AF, Mustafa A (2007) A review of heat treatment on polyacrylonitrile fiber. Polym Degrad Stab 92:1421–1432

    Article  Google Scholar 

  5. Nunna S, Creighton C, Hameed N, Naebe M, Henderson LC, Setty M, Fox BL (2017) Radial structure and property relationship in the thermal stabilization of PAN precursor fibres. Polym Test 59:203–211

    Article  Google Scholar 

  6. Park SJ, Heo GY (2015) Precursors and manufacturing of carbon fibers. Springer, Dotretch

    Book  Google Scholar 

  7. Nguyenthai NU, Hong SC (2013) Structural evolution of poly(acrylonitrile-co-itaconic acid) during thermal oxidative stabilization for carbon materials. Macromolecules 46:5882–5889

    Article  Google Scholar 

  8. Simitzis JC, Georgiou PC (2015) Functional group changes of polyacrylonitrile fibres during their oxidative, carbonization and electrochemical treatment. J Mater Sci 50:4547–4564. https://doi.org/10.1007/s10853-015-9004-2

    Article  Google Scholar 

  9. Liu J, Yue Z, Fong H (2009) Continuous nanoscale carbon fibers with superior mechanical strength. Small 5:536

    Article  Google Scholar 

  10. Liu Y, Kumar S (2012) Recent progress in fabrication, structure, and properties of carbon fibers. Polym Rev 52:234–258

    Article  Google Scholar 

  11. Xue Y, Liu J, Lian F, Liang J (2013) Effect of the oxygen-induced modification of polyacrylonitrile fibers during thermal-oxidative stabilization on the radial microcrystalline structure of the resulting carbon fibers. Polym Degrad Stab 98:2259–2267

    Article  Google Scholar 

  12. Ko T, Huang L (1992) Preparation of high-performance carbon fibres from PAN fibres modified with cobaltous chloride. J Mater Sci 27:2429–2436. https://doi.org/10.1007/BF01105054

    Article  Google Scholar 

  13. Chen JC, Harrison IR (2002) Modification of polyacrylonitrile (PAN) carbon fiber precursor via post-spinning plasticization and stretching in dimethyl formamide (DMF). Carbon 40:25–45

    Article  Google Scholar 

  14. Zhao W, Lu Y, Jiang J, Hu L, Zhou L (2015) The effect of γ-ray irradiation on the microstructure and thermal properties of polyacrylonitrile fibers. RSC Adv 5:23508–23518

    Article  Google Scholar 

  15. Wang Y, Yin W (2011) Chemical modification for PAN fibers during heat-treatment process. Phys Procedia 18:202–205

    Article  Google Scholar 

  16. Li X, Qin A, Zhao X, Ma B, He C (2014) The plasticization mechanism of polyacrylonitrile/1-butyl-3-methylimidazolium chloride system. Polymer 55:5773–5780

    Article  Google Scholar 

  17. Zhou L, Lu Y, Zhao W, Yang C, Jiang J (2016) Effects of gamma ray irradiation on poly(acrylonitrile-co-methyl acrylate) fibers. Polym Degrad Stab 128:149–157

    Article  Google Scholar 

  18. Zhao W, Lu Y, Wang J, Chen Q, Zhou L, Jiang J, Chen L (2016) Improving crosslinking of stabilized polyacrylonitrile fibers and mechanical properties of carbon fibers by irradiating with γ-ray. Polym Degrad Stab 133:16–26

    Article  Google Scholar 

  19. Liu C, Dong W, Song J, Liu L (2007) Evolution of microstructure and properties of phenolic fibers during carbonization. Mater Sci Eng A 459:347–354

    Article  Google Scholar 

  20. Ying Y, Pan Y, Ren R, Dang J, Liu C (2013) Effect of the molecular structure of phenolic novolac precursor resins on the properties of phenolic fibers. Mater Chem Phys 143:455–460

    Article  Google Scholar 

  21. Liu C, Guo Q, Shi J, Liu L (2005) A study on crosslinking of phenolic fibers. Mater Chem Phys 90:315–321

    Article  Google Scholar 

Download references

Acknowledgements

Financial support of this work by the National Natural Science Foundation of China (No. 51672042) is gratefully acknowledged.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Yonggen Lu.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Huang, F., Lu, Y., Chen, L. et al. A new polyacrylonitrile fiber for direct carbonization without oxidation. J Mater Sci 53, 8232–8240 (2018). https://doi.org/10.1007/s10853-018-2158-y

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10853-018-2158-y

Keywords

Navigation