Erratum to: On the selection of Ti–Cu alloys for thixoforming processes: phase diagram and microstructural evaluation

The Original Article is available

Erratum to: J Mater Sci (2015) 50:8007–8017 DOI 10.1007/s10853-015-9367-4

The authors regret that some minor errors were found in our paper. However, it is important to note that they did not affect the contributions and conclusions of the investigation.

The values in the scale bars shown in Fig. 5b and d in the original article are incorrect; the reader should read 1.5 and 3 mW/mg, respectively. On page 8012, column 2, paragraph 4, the word solidus is misused twice; the reader should read liquidus instead. On page 8016, column 1, paragraph 1, the word eutectoid is unfortunately misused; the reader should read eutectic instead.

We would like to apologize for any inconvenience caused.

Fig. 5
figure5

Heat flow versus temperature curves of the Ti–25Cu, Ti–27Cu, and Ti–29Cu alloys at scan rates of 10 and 40 °C min−1 during a heating (melting), b a magnification of ‘(a)’ (considering only the 10 °C min−1 rate), c cooling (solidification) and d a magnification of ‘(c)’ (also considering only the 10 °C min−1 rate) (Color figure online)

Author information

Affiliations

Authors

Corresponding author

Correspondence to Rubens Caram.

Additional information

The online version of the original article can be found under doi:10.1007/s10853-015-9367-4.

Rights and permissions

Reprints and Permissions

About this article

Verify currency and authenticity via CrossMark

Cite this article

Campo, K.N., de Lima, D.D., Lopes, É.S.N. et al. Erratum to: On the selection of Ti–Cu alloys for thixoforming processes: phase diagram and microstructural evaluation. J Mater Sci 51, 9912–9913 (2016). https://doi.org/10.1007/s10853-016-0207-y

Download citation