Skip to main content

Advertisement

SpringerLink
Log in

Influence of surface modification of alumina on bond strength in Al2O3/Al/Al2O3 joints

  • Proceedings of the IV International Conference High Temperature Capillarity
  • Published:
Journal of Materials Science Aims and scope Submit manuscript

Abstract

The subject of the work was to study the effect of Ti thin film on alumina ceramic on mechanical strength and fracture character of Al2O3/Al/Al2O3 joints. The joints were formed by liquid state bonding of alumina substrates covered with titanium thin film of 800 nm thickness using Al interlayer of 30μm thickness at temperature of 973 K in a vacuum of 0.2 mPa for 5 min. The bend strength was measured by four–point bending test at room temperature. Scanning and transmission electron microscopy were applied for detailed characterization of interface structure and failure character of fractured joint surfaces.

Result analysis has shown that application of the Ti thin film on alumina leads to decrease of bond strength properties of Al2O3/Al/Al2O3 joints along with the change either of structure and chemistry of interface or of failure character.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. R. R. TUMMALA and E. J. RYMASZEWSKI, “Microelectronic Packaging Handbook” (Van Nostrand Reinhold, New York, NY, 1989).

    Google Scholar 

  2. R. A. MARKS, D. R. CHAPMAN, D. T. DANIELSON and A. M. GLAESER, Acta Materialia 48 (2000) 4425.

    Article  CAS  Google Scholar 

  3. A. G. EVANS and B. J. DALGLEISH, Mater. Sci. Engng. A162 (1993) 1.

    Article  CAS  Google Scholar 

  4. B. J. DALGLEISH, E. SAIZ, A. P. TOMSIA, R. M. CANNON and R. O. RITCHIE, Scripta Metallurgica et Materialia 31 (1994) 1109.

    Article  CAS  Google Scholar 

  5. K. SUGANUMA, J. Mater. Sci. 26 (1991) 6144.

    Article  CAS  ADS  Google Scholar 

  6. M. KSIAZEK, N. SOBCZAK, B. MIKULOWSKI, W. RADZIWILL and I. SUROWIAK, Trans. J W R I 30 (2001) 119.

    CAS  Google Scholar 

  7. M. KSIAZEK, N. SOBCZAK, B. MIKULOWSKI and W. RADZIWILL, in Proc. Joining of Advanced and Specialty Materials V, edited by J. E. Indacochea, J. N. DuPont, T. J. Lienert, W. Tillmann, N. Sobczak, W. F. Gale, M. Singh (Columbus, Ohio, USA 2002) p. 96

  8. N. SOBCZAK, R. ASTHANA, M. KSIAZEK, W. RADZIWILL and B. MIKULOWSKI, Metallurg. and Mater. Trans. A 35A (2004) 911.

    Article  CAS  ADS  Google Scholar 

  9. M. D. DRORY, M. D. THOULESS and A. G. EVANS, Acta Metallurgica 36 (1998) 2019.

    Article  Google Scholar 

  10. R. O. RITCHIE, R. M. CANNON, B. J. DALGLEISH, R. H. DANSKARDT and J. M. McNANEY, Mater. Sci. Engng. A166 (1993) 221.

    Article  CAS  Google Scholar 

  11. O. RADDATZ, G. A. SCHNEIDER, W. MACKENS, H. VOSS and N. CLAUSSEN, J. Europ. Ceram. Soc. 20 (2000) 2261.

    Article  CAS  Google Scholar 

  12. F. S. OHUCHI and M. KOHYAMA, J. Amer. Ceram. Soc. 74 (1991) 1163.

    Article  CAS  Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Foundry Research Institute, 73 Zakopianska St., 30-418, Cracow, Poland

    M. Ksiazek, N. Sobczak & W. Radziwill

  2. AGH University of Science and Technology, 30 Mickiewicza Ave., 30-059, Cracow, Poland

    B. Mikulowski, B. Winiarski & M. Wojcik

Authors
  1. M. Ksiazek
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. N. Sobczak
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. B. Mikulowski
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. W. Radziwill
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. B. Winiarski
    View author publications

    You can also search for this author in PubMed Google Scholar

  6. M. Wojcik
    View author publications

    You can also search for this author in PubMed Google Scholar

Rights and permissions

Reprints and permissions

About this article

Cite this article

Ksiazek, M., Sobczak, N., Mikulowski, B. et al. Influence of surface modification of alumina on bond strength in Al2O3/Al/Al2O3 joints. J Mater Sci 40, 2513–2517 (2005). https://doi.org/10.1007/s10853-005-1984-x

Download citation

  • Received:

  • Accepted:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10853-005-1984-x

Keywords

Search

Navigation