Abstract
Interfacial phenomena can have a major effect on high temperature processes; these are reviewed and examples given. Interfacial phenomena have been divided into the following categories (i) Marangoni flows, (ii) Wetting, (iii) Emulsions, (iv) Foams, and (v) Jets and surface waves. Examples and case histories are given for each of the above categories.
Similar content being viewed by others
References
K. C. MILLS and B. J. KEENE, Intern. Mater. Rev. 35 (1990) 185.
M. FERRARI, L. LIGGIERI, F. RAVERA, C. AMODIO and R. MILLER, J. colloid Inter. Sci. 186 (1997) 40.
P. V. RIBOUD and L. D. LUCAS, Canad. Metallurg. Quart. 20 (1981) 199.
C. A. HEIPLE, J. R. ROPER, R. T. STAGNER and R. J. ADEN, Weld. J. 62 (1982) 72s.
P. D. LEE, P. N. QUESTED and M. McLEAN, in “Marangoni and Interfacial Phenomena in Materials Processing” edited by E. D. Hondros, M. McLean and K. C. Mills (Institute of Materials, London, 1998) p. 213.
D. SCHWABE, A. SCHARMANN, F. PREISSLER and R. VEDER, J. Cryst. Growth 43 (1978) 305.
T. HIBIYA, in “Marangoni and Interfacial Phenomena in Materials Processing” edited by E. D. Hondros, M. McLean and K. C. Mills (Institute of Materials, London, 1998) p. 85.
S. K. LAU and S. C. SINGH, J. Mater. Sci. 18 (1983) 3743.
K. MUKAI, in “Marangoni and InterfacialPhenomena in Materials Processing” edited by E. D. Hondros, M. McLean and K. C. Mills (Institute of Materials, London, 1998) p. 201.
M. HOLT, D. L. OLSON and C. E. CROSS, Scripta Metallurgica 26 (1992) 1119.
T. TAKASU and J.M. TOGURI, in “Marangoni and Interfacial Phenomena in Materials Processing” edited by E. D. Hondros, M. McLean and K. C. Mills (Institute of Materials, London, 1998) p. 153.
K. BAIN, Private Communication, Corus Teesside Technology Centre, Grangetown, Middlesborough, 2001.
P. R. SCHELLER, in Proceeding of 3rd International Conference on Continuous Casting, Madrid, p. 797.
D. A. GASKELL and A. SAELIM, Philosoph. Trans. Royal Soc. of London 336 (1998) 995.
J. K. BRIMACOMBE, A. D. GRAVES and D. INMAN, Chem. Engng. Sci. 25 (1970) 1817.
D. AGBLE and A. MENDES-TATSIS, Intern. J. Heat and Mass Transf. 43 (2000) 1025.
R. MONTI, R. SAVINO and S. TEMPESTA, Europ. J. Mechan.-B: Fluids 17 (1998) 51.
K. MUKAI, L. F. LI and T. MATSUSHITA, Tetsu-to-Hagane 90 (2004) 439.
R. MINTO and W. G. DAVENPORT, Trans. Inst. Min. and Metall. 81C (1972) C36.
S. RIAZ, K.C. MILLS and K. BAIN, in Proceedings of International Conference of Science and Technology of Steelmaking, (Swansea) (Institute of Materials, London, 2001), p. 275.
A. A. KAZAKOV, Y. MATVEEV, L. ARYKOVA and V. RYABOV, Russ. Metall. 4 (1993) 94.
M. G. POLLACK, R. B. FAIR and A. D. SHENDEROV, Appl. Phys. Lett. 77 (2000) 1725.
A. A. KAZAKOV, Russ. Metall. 6 (1997) 25.
Y. CHUNG, “Surface and Interfacial Phenomena of Liquid Iron Alloys”, PhD Thesis Department of Materials Science and Engineering, Carnegie-Mellon University, PA, April (1999).
C. F. COOPER and J. KITCHENER, J. Iron Steel Inst. 193 (1959) 48.
J. H. SWISHER and C. L. McCABE, Trans. Metall. Soc. AIME 230 (1966) 1669.
K. ITO and R. J. FRUEHAN, Metall. Trans. 20B (1989) 509.
C. W. NEXHIP, S. SUN and S. JAHANSHAHI, Philosoph. Trans. Royal Soc. London 336 (1998) 995.
L. RAYLEIGH, Proceed. Royal Soc. London 29 (1879) 71.
J. BERG, Canad. Metall. Quart. 21 (1982) 121.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Mills, K.C., Hondros, E.D. & Li, Z. Interfacial phenomena in high temperature processes. J Mater Sci 40, 2403–2409 (2005). https://doi.org/10.1007/s10853-005-1966-z
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/s10853-005-1966-z