References
P. F. JACOBS, in “Stereolithography and other RP&M Technologies form Rapid Prototyping to Rapid Tooling” (ASME Press, 1996).
D. Y. YANG and H. K. SOHN, J. Kor. Soc. Prec. Engng. 17 (2000) 5.
P. KULKARNI, A. MARSAN and D. DUTTA, Rap. Prototyp. J. 6 (2000) 18.
D. G. AHN, S. H. LEE and D. Y. YANG, Proc. Inst. Mech. Engrs. 216 (2002) 1239.
S. H. LEE, D. G. AHN and D. Y. YANG, Int. J. Adv. Mech. Manuf. Tech. 22 (2003) 175.
D. G. AHN, S. H. LEE and D. Y. YANG, ibid. 43 (2003) 1447.
B. DE SMIT and H. J. BROEK, in Proceedings of Solid Freeform Fabrication Symposium 2004, edited by D. L. Bourell, R. H. Crawford, J. J. Beaman, K. L. Wood, and H. L. Marcus, August (2004) p. 591.
D. G. AHN, S. H. LEE and D. Y. YANG, J. Mater. Sci. 21 (2002) 747.
H. C. KIM, D. G. AHN, S. H. LEE and D. Y. YANG, Int. J. Mech. Tools Manuf. 45 (2005) 345.
A. VISWANATHAN, M. JOUANEH, P. DATSERIS and W. J. PALM, IEEE Robot. Autom. Maga. 32 (1996) 39.
!M. JOUANEH, A. HAMMAD, P. DATSERIS, Int. J. Mech. Tools Manuf. 37 (1997) 437.
ESI Group, in “SYSWELD+2.0 Reference Manual” (SYSTUS International, New York, 1972).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ahn, DG., Lee, SH. & Yang, DY. Influence of process parameters on the surface roughness in hotwire cutting of EPS foam sheet for VLM-S rapid prototyping process. J Mater Sci 40, 5699–5702 (2005). https://doi.org/10.1007/s10853-005-1192-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10853-005-1192-8