Abstract
A new approximate approach is proposed to find upper-bound estimates for the critical loads of ribbed shells. Seventeen cases are considered, and the minimum critical load parameter is determined
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
S. V. Aleksandrovskii, “Stability of cylindrical shells with large deflections,” Rasch. Prostr. Konstr., 3, 453–492 (1955).
I. Ya. Amiro, O. A. Grachev, V. A. Zarutskii, et al., Stability of Ribbed Shells of Revolution [in Russian], Naukova Dumka, Kiev (1987).
I. Ya. Amiro, G. I. Diamant, and V. A. Zarutskii, “Buckling modes of longitudinally reinforced cylindrical shells,” Int. Appl. Mech., 13, No. 9, 943–944 (1977).
I. Ya. Amiro and V. A. Zarutskii, Theory of Ribbed Shells, Vol. 2 of the five-volume series Methods of Shell Design [in Russian], Naukova Dumka, Kiev (1980).
I. Ya. Amiro, V. A. Zarutskii, and P. S. Polyakov, Ribbed Cylindrical Shells [in Russian], Naukova Dumka, Kiev (1973).
I. Ya. Amiro and A. S. Pal’chevskii, “Influence of the polynomial approximation of the deflection on the critical axial-compression stresses of stringer-reinforced cylindrical shells,” Sopr. Mater. Teor. Sooruzh., 29, 25–28 (1973).
I. Ya. Amiro and N. Ya. Prokopenko, “Refinement of critical loads for a ribbed cylindrical shell obtained on the basis of a monomial displacement approximation,” Int. Appl. Mech., 23, No. 7, 626–631 (1987).
G. D. Gavrilenko, Stability of Ribbed Cylindrical Shells with an Inhomogeneous Stress-Strain State [in Russian], Naukova Dumka, Kiev (1989).
G. D. Gavrilenko, Stability of Imperfect Ribbed Shells [in Russian], Inst. Mat. NAN Ukrainy, Kiev (1999).
A. N. Guz, Stability of Three-Dimensional Deformable Bodies [in Russian], Naukova Dumka, Kiev (1971).
A. N. Guz, V. S. Zelenskii, and Yu. V. Kokhanenko, “Solving three-dimensional problems of elastic stability for plates and rods with an inhomogeneous subcritical state,” Mekh. Komp. Mater., No. 1, 49–52 (1980).
A. N. Guz and Yu. V. Kokhanenko, “Solution of plane problems of the three-dimensional theory of elastic stability of plates for inhomogeneous subcritical states,” Int. Appl. Mech., 13, No. 12, 1227–1234 (1977).
S. N. Kan, O. A. Byrsan, O. A. Alifanova, et al., Stability of Shells [in Russian], Izd. Kharkov. Univ., Kharkov (1970).
G. D. Gavrilenko, “Stability of cylindrical shells with local imperfections,” Int. Appl. Mech., 38, No. 12, 1496–1500 (2002).
G. D. Gavrilenko, “Numerical and analytical approaches to the stability analysis of imperfect shells,” Int. Appl. Mech., 39, No. 9, 1029–1045 (2003).
G. D. Gavrilenko, “Stability and load-bearing capacity of smooth and ribbed shells with local dents,” Int. Appl. Mech., 40, No. 9, 970–993 (2004).
G. D. Gavrilenko, “On a fast method for buckling load calculations of incomplete ribbed shells,” in: Theories of Plates and Shells, Springer, Berlin (2004), pp. 45–52.
D. D. Dschou, “Die Druckfestigkeit versteifter zylindrischer Schalen,” Luftfart-Forschung, 11, No. 8, 11–17 (1935).
Yu. V. Kokhanenko and V. S. Zelenskii, “Influence of geometrical parameters on the critical load in three-dimensional stability problems for rectangular plates and beams,” Int. Appl. Mech., 39, No. 9, 1073–1080 (2003).
A. Van der Neut, “The general instability of stiffened cylindrical shells under axial compression,” National Aeronautical Research Institute, Amsterdam (1947).
Author information
Authors and Affiliations
Additional information
__________
Translated from Prikladnaya Mekhanika, Vol. 41, No. 12, pp. 74–83, December 2005.
Rights and permissions
About this article
Cite this article
Gavrilenko, G.D., Matsner, V.I. Analytic upper-bound estimates for the critical loads of perfect ribbed shells. Int Appl Mech 41, 1391–1398 (2005). https://doi.org/10.1007/s10778-006-0047-6
Received:
Issue Date:
DOI: https://doi.org/10.1007/s10778-006-0047-6