Abstract
The Mercury Radiometer and Thermal Infrared Spectrometer (MERTIS) onboard the European–Japanese space mission BepiColombo to Mercury will be launched in 2014. The MERTIS scientific objective is to identify rock-forming minerals and measure surface temperatures by infrared spectroscopy (7 μm to 14 μm) and spectrally unresolved infrared radiometry (7 μm to 40 μm). To achieve this goal, MERTIS utilizes two onboard infrared calibration sources, the MERTIS blackbody at 700 K (MBB7) and the MERTIS blackbody at 300 K (MBB3), together with deep space observations corresponding to 3 K. All three sources can be observed one after the other using a rotating mirror system. The leaders of the project MERTIS are the Westfälische University of Münster, institute for planetary investigation, Mr. Prof. Dr. H. Hiesinger (PI) and the DLR, Institute of Planetary Research Berlin-Adlershof, Mr. Dr. J. Helbert (CoPI). Both blackbody radiators have to fulfill the severe mass, volume, and power restrictions of MERTIS. The radiating area of the MBB3 is based on a structured surface with a high-emissivity space qualified coating. The relatively high emissivity of the coating was further enhanced by a pyramidal surface structure to values over 0.99 in the wavelength range from 5 μm to 10 μm and over 0.95 in the wavelength range from 10 μm to 30 μm. The MBB7 is based on a small commercially available surface emitter in a standard housing. The windowless emitter is an electrically heated resistor, which consists of a platinum structure with a blackened surface on a ceramic body. The radiation of the emitter is expanded and collimated through use of a parabolic mirror. The design requirements and the radiometric and thermometric characterization of these two blackbodies are described in this paper.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
BepiColombo Project Team, Experiment Interface Document Part A - BepiColombo, Issue 1, Revision 0, European Space Agency (ESA, Noordwijk, 2008)
Grard R., Novara M., Scoon G.: ESA Bull. 103, 47 (2000)
J. Hollandt, R. Friedrich, B. Gutschwager, D.R. Taubert, J. Hartmann, High Temp. High Press. 35/36, 379 (2003/2004)
B. Gutschwager, J. Fischer, in Proceedings of TEMPMEKO ‘99, 7th International Symposium on Temperature and Thermal Measurements in Industry and Science, ed. by J.F. Dubbeldam, M.J. de Groot (Edauw Johannissen bv, Delft, 1999), pp. 567–572
Monte C., Hollandt J.: High Temp. High Press. 39, 151 (2010)
Monte C., Hollandt J.: Metrologia 47, 172 (2010)
Open Access
This article is distributed under the terms of the Creative Commons Attribution Noncommercial License which permits any noncommercial use, distribution, and reproduction in any medium, provided the original author(s) and source are credited.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
Open Access This is an open access article distributed under the terms of the Creative Commons Attribution Noncommercial License (https://creativecommons.org/licenses/by-nc/2.0), which permits any noncommercial use, distribution, and reproduction in any medium, provided the original author(s) and source are credited.
About this article
Cite this article
Gutschwager, B., Driescher, H., Herrmann, J. et al. Characterization of the 300 K and 700 K Calibration Sources for Space Application with the Bepicolombo Mission to Mercury. Int J Thermophys 32, 1429–1439 (2011). https://doi.org/10.1007/s10765-011-0979-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10765-011-0979-x