Abstract
In 2008/2009 an intercomparison of temperature block calibrators (TBCs) was carried out among 17 DKD accredited laboratories with Physikalisch-Technische Bundesanstalt (PTB) as the pilot laboratory. Within the framework of this intercomparison, different types of block calibrators were investigated in the temperature range between −24 °C and 600 °C. It was discovered that the devices have become significantly better during the past 10 years. As an example, the axial temperature distribution of the actual generation of TBCs is about ten times better than during the intercomparison of 1998. The results were improved in the same level and demonstrate the present capabilities of accredited laboratories in Germany.
Similar content being viewed by others
References
Calibration Guide, EURAMET/cg-13/v.01, Calibration of Temperature Block Calibrators (2007)
S. Friederici, E. Tegeler, in Proceedings of the 8th International Symposium on Temperature and Thermal Measurements in Industry and Science, vol. 2, ed. by B. Fellmuth, J. Seidel, G. Scholz (VDE Verlag GmbH, Berlin and Offenbach, 2002), pp. 1025–1030
J. Nielsen, Report of Proficiency Test, Reg. no. 200 (Danish Technological Institute, DANAK, 2007)
O. Kerkhof, A.M.H. van der Veen, Evaluation Report, ILC Dry Block Calibrator, Report Code S-TH-07.02 (NMi Van Swinden Laboratory B.V., 2007)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Behnke, HG., Friederici, S. & Rudtsch, S. Intercomparison of Temperature Block Calibrators. Int J Thermophys 31, 1703–1709 (2010). https://doi.org/10.1007/s10765-010-0824-7
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10765-010-0824-7