An analysis of the influence produced by torsional and bending oscillations of a shaft assembly on the accuracy of measuring rotation frequency is presented. Based on the obtained data about the level of fluctuations in the frequency measurement cross-section, an assessment was made concerning possible changes in the values of the measured frequency in various operational modes of a turbine unit. The dependences of frequency change on the damping and phase shift of oscillations are obtained. A reduction in the effect of torsional oscillations on the accuracy of frequency measurement can be achieved by selecting the location of frequency measurement in the nodal point zone of natural modes—in particular, in the span between the generator and turbine bearings.
Similar content being viewed by others
References
GOST R 55890. Unified Energy System and Isolated Energy Systems. Operational Dispatch Control. Frequency Regulation of Power Flows. Norms and Requirements [in Russian] (2013).
I. Z. Chernomzav and K. A. Nefedov, “Improvement of control systems for high power steam turbines,” Teploénergetika, No. 10, 27 – 33 (2010).
D. V. Taradai, Yu. A. Deomidova, A. Z. Zile, and S. B. Tomashevskii, “Research results of shafting torsional oscillations in turbine units,” Teploénergetika, No. 1, 23 – 33 (2018).
A. A. Kalashnikov, Dynamics of Turbine Regulation [in Russian], Énergoatomizdat, Moscow (1999).
A. Z. Zile, V. V. Komarov, M. N. Rudenko, and S. B. Tomashevskii, “Vibrodiagnostic control of turbine units in the energy sector,” Teploénergetika, No. 4, 7 – 11 (2004).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Élektricheskie Stantsii, No. 8, August 2021, pp. 41 – 47. DOI: https://doi.org/10.34831/EP.2021.1081.8.006
Rights and permissions
About this article
Cite this article
Zile, A.Z., Chernomzav, I.Z. The Effect of Shafting Oscillations in the Turbo Unit on the Accuracy of Rotation Frequency Measurement. Power Technol Eng 55, 742–748 (2022). https://doi.org/10.1007/s10749-022-01426-3
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10749-022-01426-3