The most reliable diagnostic signs of the limit state of the pumping equipment at production plants are established to minimize the outage time.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
A. A. Korneev and A. S. Lyubimova, “Analyzing the causes of failure of centrifugal pumps for housing and communal services and repair technologies,” Serv. Rossii Rubezh., No. 8(35), 172 – 179 (2012).
A. A. Fed’ko and A. A. Sorokin, “Dry-running protection of pumps,” Izv. Orenburg. Gos. Agragr. Univ., No. 1, 48 – 50 (2014).
V. A. Vasil’ev and A. Yu. Nitskii, “Analyzing failures of shafts of feed-water pumps at large power units,” Vestn. Yuzh.-Ural. Gos. Univ., No. 1(41), 78 – 93 (2005).
A. Adam, H. Adam, and L. Mariusz, “Resonance of torsional vibrations of centrifugal pump shafts due cavitation erosion of pump impellers,” Eng. Fail. Anal., 70, 56 – 72 (2016).
N. P. Ovchinnikov, “Operational capability of an electric pump unit with new and worn rotor wheels,” Power Technol. Eng., 51(3), 298 – 302 (2017).
N. P. Ovchinnikov and I. V. Zyryanov, “Assessment of the life of sectional pumps of the ALROSA underground kimberlite mines,” Gornyi Zh., No. 10, 41 – 44 (2017).
O. M. Brusova, “On improvement of the service life of dredging pumps,” Vestn. Perm. Nats. Issl. Politekhn. Univ. Geol. Neftegaz. Gorn. Delo, 13(10), 98 – 106 (2014).
S. Fabian and P. Èaèko, “Experimental measurement and examination of independent and combined interaction of vibrodiagnostic and tribotechical methods,” Appl. Mech. Mater., 308, 51 – 56 (2013).
G. Janicki, A. Perzouvanis, B. Mason, and M. K. Ebrahimi, “Turbine blade vibration measurement methods for turbocharges,” Am. J. Sensor Technol., 2(2), 13 – 19 (2014).
P. B. Gerike and V. L. Blyumenshtein, “Results of vibration diagnostics of centrifugal pumps with reference to a unified criterion for assessment of their actual condition,” Vestn. Kuzbass. Gos. Tekhn. Univ., No. 6, 89 – 96 (2016).
P. B. Gerike, “Creating preconditions for developing criteria of the limit state of screens based on analysis of the parameters of mechanical vibrations,” Vestn. Kuzbass. Gos. Tekhn. Univ., No. 1(107), 24 – 29 (2015).
V. I. Aleksandrov and J. Sobota, “Vibration diagnostics of the condition of dredging pumps,” Zap. Gorn. Inst., 218, 242 – 250 (2016).
N. P. Ovchinnikov, “Strength design of the shaft of a pump with worn-out impeller,” Vestn. Mordov. Univ., 27(4), 592 – 606 (2017).
S. S. Men’shikov and M. A. Vasil’eva, “Coefficient of technical condition of a dredging pump in hydraulic transport of slurry tailings,” Zap. Gorn. Univ., 209, 193 – 196 (2014).
M. A. Vikulov, N. P. Ovchinnikov, and D. E. Makhno, “Measurements of section pump of rotor axial position at Udachny mine,” Adv. Eng. Res., 133, 884 – 891 (2017).
N. P. Ovchinnikov and A. G. Smyslov, “Some problems of operation of the main drainage pumps of the Udachny underground mine,” Gorn. Inform.-Analit. Byull., Special issue 24: Geomechanical and Geotechnological Problems of the Development of Northern Subsoils, 83 – 92 (2017).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Gidrotekhnicheskoe Stroitel’svo, No. 8, August, 2018, pp. 49 – 52.
Rights and permissions
About this article
Cite this article
Ovchinnikov, N.P. Improving the Reliability of Pumping Equipment at Production Plants. Power Technol Eng 52, 552–554 (2019). https://doi.org/10.1007/s10749-019-00992-3
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10749-019-00992-3