It is determined on the basis of experimental data and calculations that frost-resistant ceramics can be obtained from a mixture of low-melting illite-bearing clays without other, more expensive, refractory clays. Techniques for planning “property–property” experiments were used to formulate the molding mixes. For the optimal content of the molding mixes, a sintered ceramic material with frost-resistance of more than 250 cycles with omni-directional freezing and from 75 to 125 cycles with uni-directional freezing was obtained.
Similar content being viewed by others
References
S. B. Cannon and A. M. Wynn, “A new method for establishing the upper and lower limits of clay plastic behavior,” Tile Brick Int., No. 2, 82–89 (1999).
A. G. Tkachev, A. Ya. Kozyarenii, and O. N. Tkacheva, “Optimization of brick paste formulation according to the drying properties,” Steklo Keram., No. 8, 33–34 (1999).
R. Žurauskienë, R. Mačiulaitis, and F. Petrikaitis, “Usability of Lithuanian fusible clay for sintered ceramics,” Statuba (Civil Eng.), VII(3), 191–196 (2001).
D. Daunoravičiutë, F. Petrikaitis, A. Lasus, and V. Jarulaitis, “Clays for the ceramics industry in Lithuania,” Tile Brick Int., No. 1, 34–37 (1997).
Author information
Authors and Affiliations
Additional information
Translated from Steklo i Keramika, No. 3, pp. 9–12, March, 2009.
Rights and permissions
About this article
Cite this article
Žurauskienë, R., Mačiulaitis, R. & Yakovlev, G.I. Optimal mix for building ceramics. Glass Ceram 66, 86–89 (2009). https://doi.org/10.1007/s10717-009-9134-6
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10717-009-9134-6