Abstract
The possibility of using a small VIMS-1 device for measuring the electrophysical properties of abrasive molding pastes made of micropowders in developing formulas for an abrasive tool and for controlling the quality of the pastes in production conditions was examined. It was shown that introduction of control of the electrophysical properties of molding pastes is a real possibility for obtaining molding pastes of stable quality.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
A. N. Krasnov and A. M. Tsyv’yan, “Abrasive tool made of silicon carbide micropowders in a ceramic binder,” Steklo Keram., No. 7, 33–35 (2007).
V. N. Lyubomudrov, N. N. Vasil’ev, and B. I. Fal’kovskii, Abrasive Tools and Their Manufacture [in Russian], Mashgiz, Moscow-Leningrad (1953).
G. V. Kukolev, Chemistry of Silicon and Physical Chemistry of Silicates [in Russian], Vysshaya Shkola, Moscow (1966).
B. A. Glagovskii, G. Sh. Roititein, and V. A. Yashin, Control-Measuring Instruments and Principles of Automation of Production of Abrasive Tools [in Russian], Mashinostroenie, Leningrad (1980).
E. Z. Kovarskaya and A. M. Tsyv’yan, “Control of the moisture content of raw material and molding pastes in production of an abrasive tool,” in: Proceed. of the Sci.-Pract. Seminar “Experience in Industrial Use of Nondestructive Quality Control of Nonmetallic Articles, Cast Iron, and Composites” [in Russian], St. Petersburg (2007), p. 29.
Author information
Authors and Affiliations
Additional information
__________
Translated from Steklo i Keramika, No. 10, pp. 34–37, October, 2007.
Rights and permissions
About this article
Cite this article
Tsyv’yan, A.M., Kovarskaya, E.Z. Control of molding pastes for an abrasive tool made of silicon carbide and electrocorundum micropowders in a ceramic binder. Glass Ceram 64, 369–372 (2007). https://doi.org/10.1007/s10717-007-0093-5
Issue Date:
DOI: https://doi.org/10.1007/s10717-007-0093-5