Skip to main content
Log in

Field Tests of the Response of Single Pile Subjected to Lateral Load in Gravel Soil Sloping Ground

  • Original Paper
  • Published:
Geotechnical and Geological Engineering Aims and scope Submit manuscript

Abstract

The behavior for a laterally loaded pile is sophisticated when it is located in the sloping ground. The gravel soil is a typical strata of western Sichuan province of China, but the response of piles in the gravel soil ground has been very little studied. The field tests in this study were conducted to investigate the single pile response for varying gradients of gravel soil slope. Slopes with gradient 15°, 30°, 45° were chosen, and the pile deflection, bending moment, earth pressure and lateral bearing capacity were recorded and analyzed. The results demonstrated that when the slope gradient increases, the displacement of pile top, bending moment of pile shaft and earth pressure increase, but the lateral bearing capacity of pile decreases. It is also found that the depth at which these maximum values occur moves downward as the ground gradient increases. Comparing test results with calculated results of lateral bearing capacity provides a modification for the existing formulas proposed in design procedures. The modified formulas can be applied to the design of single pile imbedded in gravel soil sloping ground.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16

Similar content being viewed by others

Abbreviations

\({\text{R}}_{\text{ha}}\) :

Pile horizontal bearing capacity (kN)

R ha0 :

Pile horizontal bearing capacity of horizontal ground (kN)

α :

Horizontal deformation coefficient

γ m :

Plasticity coefficient of pile section modulus

f t :

Design tensile strength of concrete (MPa)

W 0 :

Pile cross section modulus of pulled edge (MPa)

υ m :

Maximum bending moment coefficient of pile

ρ g :

Pile reinforcement ratio (%)

ξ N :

Pile top vertical force influence coefficient

N :

Pile top vertical force (kN)

A n :

Pile conversion sectional area (m2)

EI :

Flexural rigidity

υ x :

Pile top horizontal displacement coefficient

x 0 a :

Allowing horizontal displacement of pile top

η s :

Modification factor of slope gradient

s:

Slope gradient in radian

References

Download references

Author information

Authors and Affiliations

Authors

Contributions

HJY carried out the test and drafted the manuscript. SQP and QHZ provided a test site and assisted in the field test. All authors read and approved the final manuscript.

Corresponding author

Correspondence to Haojun Yu.

Ethics declarations

Conflict of interest

The authors declare that they have no competing interest.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Yu, H., Peng, S. & Zhao, Q. Field Tests of the Response of Single Pile Subjected to Lateral Load in Gravel Soil Sloping Ground. Geotech Geol Eng 37, 2659–2674 (2019). https://doi.org/10.1007/s10706-018-00785-x

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10706-018-00785-x

Keywords

Navigation