Skip to main content
Log in

Laboratory Study of the Effect of Degrees of Saturation on Lime Concrete Resistance Due to the Groundwater Level Increment

  • Original paper
  • Published:
Geotechnical and Geological Engineering Aims and scope Submit manuscript

Abstract

Lime concrete and lime treatment are two attractive techniques for geotechnical engineers in the construction of rail tracks and pavement layers, in slope protection of earth dams, and as a support layer for shallow foundations. The present study investigates the influence of different degrees of saturation upon the unconfined compressive strength (qu) of lime concrete. At first, the characteristics of used materials were determined. Then, the optimum amounts of water and clay soil were determined based on flow table tests and uniaxial compression tests. Specimens with an optimum level of clay, sand, lime, and moisture were prepared. After processing durations of 14, 28, 45, and 60 days in laboratory condition, the specimens were exposed to saturation levels ranging from 0 to 100%. The uniaxial compressive strength tests were then carried out on all specimens. The diagram of strength reduction of lime concrete versus different depths and saturation degrees (Sr) were developed. The results showed that the moisture has a significant effect on decreasing the strength of lime concrete. The specimens that placed in 100% of saturated condition failed completely, and in 20% of saturated condition, the strength value of specimens decreased about 42%. Also, the optimum percentages of clay and water for application in lime concrete with 7% lime, respectively 23 and 24.04% were determined. Based on the results of SEM test it was observed that the specimen was characterized by a rather well-structured matrix since both the filling of a large proportion of the coarse-grain soil voids by clay and the pozzolanic activity of lime led to retain less pore water in the specimen, increasing the uniaxial compressive strength, and consequently resist against swelling and shrinkage of the clay soil.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11

Similar content being viewed by others

References

  • AASHTO T180 (2010) Standard method of test for moisture-density relations of soils using a 4.54 kg (10-lb) rammer and a 457 mm (18-in.) drop. American Association of State Highway and Transportation Officials, Washington

  • Ameri M, Kalantari B, Jahandari S (2015) Laboratory study of determination of optimum amount of water and clay in mortar made with lime and fly ash. In: International conference on research in science and technology, Kualalumpur, Malaysia

  • ASTM D423–66 (1972) Standard method of test for liquid limit of soils. ASTM International West Conshohocken

  • ASTM D424–54 (1982) Standard method of test for plastic limit. ASTM International West Conshohocken

  • ASTM D422–63 (2002) Standard test method for particle-analysis of soils. ASTM International West Conshohocken

  • ASTM C270–07 (2007) Standard specification for mortar for unit masonry ASTM International West Conshohocken

  • ASTM D5102–09 (2009) Standard test methods for unconfined compressive strength of compacted soil-lime mixtures. ASTM International West Conshohocken

  • ASTM D. 854–10 (2010) Standard test methods for specific gravity of soil solids by water pycnometer. ASTM International West Conshohocken

  • ASTM 2487–11 (2011) Standard practice for classification of soils for engineering purposes (unified soil classification system). ASTM International West Conshohocken

  • ASTM C618–15 (2015) Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete. ASTM International West Conshohocken

  • Azadegan O, Li J (2015) Effects of lime and cement treated platform on the behavior of circular footing founded on soft clay. J Geotech Eng 9:214–221

    Article  Google Scholar 

  • Azadegan O, Li J, Hadi Jafari S (2014) Estimation of shear strength parameters of lime-cement stabilized granular soils from unconfined compressive tests. Geomech Eng 7:247–261

    Article  Google Scholar 

  • Cebeci OZ, Al-Noury SI, Mirza WH (1989) Strength and drying shrinkage of masonary mortars in various temperature-humidity environments. Cem Concr Res 19:53–62

    Article  Google Scholar 

  • Chan R, Bindiganavile V (2010) Toughness of fibre reinforced hydraulic lime mortar. Part-1: quasi-static response. Mater Struct 43:1435–1444

    Article  Google Scholar 

  • Consoli NC, Lopes LDS Jr, Prietto PDM, Festugato L, Cruz RC (2010) Variables controlling stiffness and strength of lime-stabilized soils. J Geotech Geoenviron Eng 137:628–632

    Article  Google Scholar 

  • Das BM (2008) Advanced soil mechanics, 3rd edn. Taylor & Francis, UK

    Google Scholar 

  • Hami A (2000) Building materials. Publication of Tehran University, Tehran

    Google Scholar 

  • Hanley R, Pavía S (2008) A study of the workability of natural hydraulic lime mortars and its influence on strength. Mater Struct 41:373–381

    Article  Google Scholar 

  • Isaia GC, Gastaldini ALG, Moraes R (2003) Physical and pozzolanic action of mineral additions on the mechanical strength of high-performance concrete. Cement Concr Compos 25:69–76

    Article  Google Scholar 

  • Jahandari S (2015) Laboratory study of moisture and capillarity impact on lime concrete resistance due to the increase of ground water level. M.Sc. thesis, Faculty of Civil and Surveying Engineering, Department of Geotechnical Engineering, Graduate University of Advanced Technology, Kerman, Iran

  • Jahandari S, Li J, Saberian M, Shahsavarigoughari M (2017a) Experimental study of the effects of geogrids on elasticity modulus, brittleness, strength, and stress-strain behavior of lime stabilized kaolinitic clay. GeoResJ 13:49–58

    Article  Google Scholar 

  • Jahandari S, Saberian M, Zivari F, Li J, Ghasemi M, Vali R (2017b) Experimental study of the effects of curing time on geotechnical properties of stabilized clay with lime and geogrid. Int J Geotech Eng 1–12

  • Malekpoor MR, Toufigh MM (2010) Laboratory study of soft soil improvement using lime mortar-(well graded) soil columns. Geotech Test J 33:1–11

    Google Scholar 

  • Osinubi KJ, Nwaiwu CMO (2006) Compaction delay effects on properties of lime-treated soil. J Mater Civ Eng 18:250–258

    Article  Google Scholar 

  • Pavia S, Treacy E (2006) A comparative study of the durability and behaviour of fat lime and feebly-hydraulic lime mortars. Mater Struct 39:391–398. doi:10.1617/s11527-005-9033-4

    Article  Google Scholar 

  • Rahgozar MA, Saberian M (2015) Physical and chemical properties of two Iranian peat types. Mires and Peat 16(07):1–17

    Google Scholar 

  • Rahgozar M, Saberian M (2016) Geotechnical properties of peat soil stabilised with shredded waste tyre chips. Mires and Peat 18(03):1–12

    Google Scholar 

  • Saberian M, Khabiri MM (2016) Effect of oil pollution on function of sandy soils in protected deserts and investigation of their improvement guidelines. Environ Geochem Health. doi:10.1007/s10653-016-9897-y

    Google Scholar 

  • Saberian M, Rahgozar MA (2016) Geotechnical properties of peat soil stabilised with shredded waste tyre chips in combination with gypsum, lime or cement. Mires and Peat 18(16):1–16. doi:10.19189/MaP.2015.OMB.211

    Google Scholar 

  • Saberian M, Jahandari S, Li J, Zivari F (2017a) Effect of curing, capillary action, and groundwater level increment on geotechnical properties of lime concrete: experimental and prediction studies. J Rock Mech Geotech Eng 1–10

  • Saberian M, Mehrinejad Khotbehsara M, Jahandari S, Vali R, Li J (2017b) Experimental and phenomenological study of the effects of adding shredded tire chips on geotechnical properties of peat. Int J Geotech Eng 1–10

  • Stefanidou M, Papayianni I (2005) The role of aggregates on the structure and properties of lime mortars. Cem Conc Compos 27:914–919

    Article  Google Scholar 

  • Toohey N, Mooney M, Bearce R (2012) Stress-strain-strength behavior of lime-stabilized soils during accelerated curing. J Mater Civ Eng 25:1180–1886

    Google Scholar 

  • Transportation Research Board (TRB) (1987). Lime stabilization-reactions, properties, design, and construction. State of the art Report No. 5, Tracsportation Research Board, Washington

  • Yang G, Liu H, Lv P, Zhang B (2012) Geogrid-reinforced lime-treated cohesive soil retaining wall: case study and implications. Geotext Geomembranes 35:112–118

    Article  Google Scholar 

Download references

Acknowledgement

This study was supported by the laboratory of soil mechanic of Abadgaran Negin Jonoobshargh Company. The authors would also like to thank the highly respected reviewers for their valuable/critical review and constructive comments.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Soheil Jahandari.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Jahandari, S., Toufigh, M.M., Li, J. et al. Laboratory Study of the Effect of Degrees of Saturation on Lime Concrete Resistance Due to the Groundwater Level Increment. Geotech Geol Eng 36, 413–424 (2018). https://doi.org/10.1007/s10706-017-0335-4

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10706-017-0335-4

Keywords

Navigation