Skip to main content
SpringerLink
Log in

The Impact of Thermal Runaway on Sprinkler Protection Recommendations for Warehouse Storage of Cartoned Lithium-Ion Batteries

  • Published:
Fire Technology Aims and scope Submit manuscript

Abstract

This study investigates the appropriateness of applying the standard large-scale fire test protocol developed for ordinary combustibles for energetic batteries. A large-scale fire test was recently conducted to determine sprinkler protection guidance for warehouse storage of lithium-ion batteries. The specific battery tested had a 20 Ah capacity, polymer pouch format, lithium iron phosphate chemistry and was at a typical state-of-charge (50%) for long-term storage. The batteries were packaged in single-wall corrugated containerboard cartons on hardwood pallets, as received from the supplier. Each carton contained 20 batteries separated by nested polystyrene plastic dividers. Acceptable ceiling-level sprinkler protection was achieved for 4.6 m (15 ft) tall rack storage under a 12.2 m (40 ft) ceiling using K-Factor of 320 L/min/bar½ (22.4 gpm/psi½), quick-response, sprinklers at a discharge pressure of 2.4 bar (35 psig). The effect that thermal runaway of the Li-ion batteries had on the design and outcome of the large-scale fire was evaluated. A focus was placed on the role of thermal runaway during three stages of the fire; ignition leading to sprinkler operation, active sprinkler protection, and conditions after the sprinkler system was turned off. An external ignition source was used in cases where induced thermal runaway, which refers to rapid self-heating of a battery under abuse conditions, did not lead to combustion of the battery contents. Through a combination of experiments and review of literature data, it was found that thermal runaway within a pallet load of cartoned batteries would result in a similar fire hazard as that associated with external ignition scenarios typically used in large-scale fire testing. Regardless of chemistry, evidence shows that fire propagation beyond the battery or carton of origin occurs external to the carton due to limited available air within the carton to support combustion. In addition, intermediate-scale testing showed that sprinkler water would be effective at suppressing a fire at a later stage of battery involvement than was achieved in the large-scale test. This work reinforces the sprinkler protection guidance resulting from the successful large-scale fire test.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11

Courtesy of Thumuluru and Xin [37]

Similar content being viewed by others

References

  1. FM Approvals Standard Class 2000 (2006) Approval Standard for Automatic Control Mode Sprinklers for Fire Protection

  2. FM Approvals Standard Class 2008 (2006) Approval Standard for Suppression Mode [Early Suppression—Fast Response (ESFR)] Automatic Sprinklers

  3. National Fire Protection Association Standard 13 (NFPA 13) (2010) Standard for the Installation of Sprinkler Systems

  4. FM Global Property Loss Prevention Data Sheet 8-9 (2011) Storage of Class 1, 2, 3, 4 and Plastic Commodities

  5. Lisbona D, Snee T (2011) A review of hazards associated with primary lithium and lithium-ion batteries. Process Saf Environ Prot 89(6):434–442. https://doi.org/10.1016/j.psep.2011.06.022

    Article  Google Scholar 

  6. Buser M (2011) Lithium batteries: hazards and loss prevention. S+S Report International, pp. 10–17

  7. Long RT, Kahn M, Mikolajczak C (2012) Lithium-ion battery hazards, fire protection engineering, pp. 20–36, 4th Quarter

  8. Doughty D, Roth EP (2012) A general discussion of Li ion battery safety. Electrochem Soc Interface 21(2):37–44. https://doi.org/10.1149/2.f03122if

    Article  Google Scholar 

  9. Ditch B, de Vries J (2013) Flammability characterization of lithium-ion batteries in bulk storage. FM Global, technical report. http://www.fmglobal.com/researchreports. Accessed 18 July 2016

  10. Ditch B (2016) Development of protection recommendations for li-ion battery bulk storage: sprinklered fire test. FM Global technical report. http://www.fmglobal.com/researchreports. Accessed 1 Nov 2016

  11. National Highway Traffic Safety Administration (NHTSA) (2012) Chevrolet Volt Battery Incident Overview Report, Washington DC, USA, Report No. DOT HS 811 573

  12. Arbizanni C, Gabrielli G, Mastragostino M (2011) Thermal stability and flammability of electrolytes for lithium-ion batteries. J Power Sources 196(10):4801–4805. https://doi.org/10.1016/j.jpowsour.2011.01.068

    Article  Google Scholar 

  13. Larsson F, Andersson P, Mellander B-E (2016) Lithium-ion battery aspects on fires in electrified vehicles on the basis of experimental abuse tests. Batteries. https://doi.org/10.3390/batteries2020009

    Google Scholar 

  14. Summer SM (2010) Flammability assessment of lithium-ion and lithium-ion polymer battery cells designed for aircraft power usage. U.S. Department of Transportation Federal Aviation Administration, DOT/FAA/AR-09/55, Springfield, VA

  15. Roth EP, Crafts C, Doughty DH, McBreen J (2004) Advanced technology development program for lithium-ion batteries: thermal abuse performance of 18650 Li-ion cells. SANDIA REPORT SAND2004-0584, Unlimited Release

  16. Abraham DP, Roth EP, Kostecki R, McCarthy K, Doughty DH (2006) Diagnostic examination of thermally abused high-power lithium-ion cells. J Power Sources 161:648–657. https://doi.org/10.1016/j.jpowsour.2006.04.088

    Article  Google Scholar 

  17. Fu Y, Lu S, Liu C, Cheng X, Zhang H (2015) An experimental study on the burning behaviors of 18650 lithium ion batteries using a cone calorimeter. J Power Sources. 273:216–222. https://doi.org/10.1016/j.jpowsour.2014.09.039

    Article  Google Scholar 

  18. Yang H, Zhuang GV, Ross PN Jr (2006) Thermal stability of LiPF6 salt and Li-ion battery electrolytes containing LiPF6. J Power Sources. 161:573–579. https://doi.org/10.1016/j.jpowsour.2006.03.058

    Article  Google Scholar 

  19. Larsson F, Andersson P, Blomqvist P, Loren A, Mellander B-E (2014) Characteristics of lithium-ion batteries during fire tests. J Power Sources. 271:414–420. https://doi.org/10.1016/j.jpowsour.2014.08.027

    Article  Google Scholar 

  20. Ribiere P, Grugeon S, Morcrette M, Boyanov S, Laruelle S, Marlair G (2012) Investigation on the fire-induced hazards of Li-ion battery cells by Fire. Energy Environ Sci 5:5271–5280. https://doi.org/10.1039/C1EE02218K

    Article  Google Scholar 

  21. Eshetu GG, Grugeon S, Laruelle S, Boyanov S, Lecocq A, Bertrand J-P, Marlair G (2013) In-depth safety-focused analysis of solvents used in electrolytes for large scale lithium ion batteries. Phys Chem Chem Phys 15:9145–9155. https://doi.org/10.1039/c3cp51315g

    Article  Google Scholar 

  22. Liu X, Wu Z, Stoliarov S, Delinger M, Masias A, Snyder K, (2016) Heat release during thermally-induced failure of a lithium ion battery: impact of cathode composition. Fire Saf J 85:10–22. https://doi.org/10.1016/j.firesaf.2016.08.001

    Article  Google Scholar 

  23. Reddy TB, Linden B (2010) Linden’s handbook of batteries, 4th edn. McGraw-Hill, New York.

  24. Golubkov A, Fuchs D, Wagner J, Wiltsche H, Stangl C, Fauler G, Voitic G, Thaler A, Hacker V (2014) Thermal-runaway experiments on consumer li-ion batteries with metal-oxide and olivin-type cathodes. RSC Adv 4:3633–3642. https://doi.org/10.1039/C3RA4578F

    Article  Google Scholar 

  25. Maloney T (2016) Lithium battery thermal runaway vent gas analysis. U.S. Department of Transportation Federal Aviation Administration, DOT/FAA/TC-15/59

  26. Long RT, Blum A (2016) Lithium ion batteries hazard and use assessment—phase III. Final report, Fire Protection Research Foundation. http://www.nfpa.org/foundation. Accessed 10 Nov 2016.

  27. Harris SJ, Timmons A, Pitz WJ (2009) A combustion chemistry analysis of carbonate solvents in li-ion batteries. J Power Sources 193:855–858. https://doi.org/10.1016/j.jpowsour.2009.04.030

    Article  Google Scholar 

  28. Khan MM, Tewarson A, Chaos M (2016) Combustion characteristics of materials and generation of fire products, ch. 36. In: Hurley MJ, Gottuk DT, Hall JR Jr, Harada K, Kuligowski ED, Puchovsky M, Torero JL, Watts JM Jr, Wieczorek CJ (eds) SFPE handbook of fire protection engineering. Springer, New York, pp 1143–1232

    Chapter  Google Scholar 

  29. Webster H (2010) Fire protection for the shipment of lithium batteries in aircraft cargo compartments. U.S. Department of Transportation Federal Aviation Administration, DOT/FAA/AR-10/31

  30. Webster H (2012) Preliminary full-scale tests with bulk shipments of lithium batteries, FAA Fire Safety Highlights

  31. Xin Y, Tamanini F (2008) Assessment of commodity classification for sprinkler protection using representative fuels. J Fire Saf Sci 9:527–538. https://doi.org/10.3801/IAFSS.FSS.9-527

    Article  Google Scholar 

  32. Kung HC, You HZ, Spaulding RD (1986) Ceiling flows of growing rack storage fires. In: Twenty-first symposium (international) on combustion, The Combustion Institute, pp 121–128. https://doi.org/10.1016/s0082-0784(88)80238-8

  33. Heskestad G (1976) Investigation of a new sprinkler sensitivity approval test: the plunge test. FMRC technical report, Serial No. 22485, RC 76-T-50

  34. Heskestad G, Smith HF (1980) Plunge test for determination of sprinkler sensitivity. FMRC technical report, J.I. 3A1E2.RR

  35. You HZ, Kung HC (1984) Strong buoyant plumes of growing rack storage fires. In: Twentieth symposium (international) on combustion, The Combustion Institute, pp 1547–1554. https://doi.org/10.1016/s0082-0784(85)80649-4

  36. Heskestad G (1980) Pressure profiles generated by fire plumes impacting on horizontal ceilings. FMRC technical report, 0F0E1.RU

  37. Thumuluru S, Xin Y (2013) An experimental study of pre-wetting on fire propagation in parallel panels. In: Proceedings of the 13th international fire science and engineering conference (INTERFLAM 2015), Windsor, UK, pp 317–326

  38. Meredith K, de Vries J, Wang Y, Xin Y (2013) A comprehensive model for simulating the interaction of water with solid surfaces in fire suppression environments. Combust Inst 34(2):2719–2726. https://doi.org/10.1016/j.proci.2012.06.094

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

  1. FM Global, Research Division, 1151 Boston-Providence Turnpike, Norwood, MA, 02062, USA

    Benjamin Ditch

Authors
  1. Benjamin Ditch
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Benjamin Ditch.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Ditch, B. The Impact of Thermal Runaway on Sprinkler Protection Recommendations for Warehouse Storage of Cartoned Lithium-Ion Batteries. Fire Technol 54, 359–377 (2018). https://doi.org/10.1007/s10694-017-0687-6

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10694-017-0687-6

Keywords

Search

Navigation